Subscribe to Our Youtube Channel
Related Manuals for PLS EALIFT
Summary of Contents for PLS EALIFT
- Page 1 Manual for safe installation and operation PASSENGER LIFT SOLUTIONS Unit 2, Summit Crescent Ind. Est. West Midlands, B66 1BT, GB. +44 (0) 121 552 0660...
- Page 2 Cleaning Care needs to be taken during the cleaning process, all cleaning should be carried out by hand using a gentle cloth or sponge soaked in non-aggressive detergent then rinsed with a cloth dampened with water. Ensure all moving parts are re-lubricated as per the lubrication section DO NOT USE AGGRESSIVE CLEANERS DO NOT USE PRESSURE WASHERS OR HOT WATER...
-
Page 3: Troubleshooting
Check for leaking oil, replace all necessary compo- nents, close tap & re-stow lift Low oil level in reservoir—air in system Top up reservoir with PLS blue hydraulic oil 25mm from top ‘MAX’ when lift stowed Lack of lubrication Spray all pivots ad moving parts with ACF-50... - Page 4 Troubleshooting Symptom Possible Cause Solution Mechanism has is stuck in down position Reset, lubricate and test bridge plate mechanism Bridge plate not returning to vertical position Gas strut has lost pressure Replace parts as necessary Platform structure bent Replace damaged components Platform knuckles not set correctly Adjust the platform knuckles at the platform pivot.
-
Page 5: End Of Life-Safe Disposal
Contact the local authority to ensure that specific materials such as lubricants and electrical / electronic components are disposed of correctly Inform PLS of disposal and return any ID plates if requested PASSENGER LIFT SOLUTIONS Unit 2, Summit Crescent Ind. Est. West Midlands, B66 1BT, GB. +44 (0) 121 552 0660... - Page 6 Pump Bleeding CLOSE OPEN OPEN VEHICLE DOORS, ENSURE AREA IS CLEAR, SLOWLY OPEN VALVE AND LOWER LIFT TO GROUND LEVEL PUMP MINIMUM 15 TIMES ONCE AT FLOOR LEVEL, REMOVE PUMP COVER KEEP LIFT AT GROUND LEVEL DURING PROCEDURE CLOSE CLOSE VALVE REMOVE AND STOW HANDLE KEEP LIFT AT GROUND LEVEL DURING PROCEDURE...
-
Page 7: Oil Level Check
BETWEEN MIN AND MAX LEVEL. IF NO DIPSTICK MAKE SURE OIL LEVEL IS 25MM BELOW OF OIL CAP HOLE. IF EITHER IS BELOW LEVELS THEN TOP UP WITH PLS BLUE HY- DRAULIC OIL. IF OVER-FILLED THEN OIL MUST BE TAKEN OUT BY LOOSENING A UNION TO DRAIN SLIGHTLY. - Page 8 PASSENGER LIFT SOLUTIONS Unit 2, Summit Crescent Ind. Est. West Midlands, B66 1BT, GB. +44 (0) 121 552 0660...
- Page 9 PASSENGER LIFT SOLUTIONS Unit 2, Summit Crescent Ind. Est. West Midlands, B66 1BT, GB. +44 (0) 121 552 0660...
- Page 10 PASSENGER LIFT SOLUTIONS Unit 2, Summit Crescent Ind. Est. West Midlands, B66 1BT, GB. +44 (0) 121 552 0660...
- Page 11 NOTE: Contact PLS for extra copies of this document PASSENGER LIFT SOLUTIONS Unit 2, Summit Crescent Ind. Est. West Midlands, B66 1BT, GB. +44 (0) 121 552 0660...
- Page 12 NOTE: Contact PLS for extra copies of this document PASSENGER LIFT SOLUTIONS Unit 2, Summit Crescent Ind. Est. West Midlands, B66 1BT, GB. +44 (0) 121 552 0660...
- Page 13 PASSENGER LIFT SOLUTIONS Unit 2, Summit Crescent Ind. Est. West Midlands, B66 1BT, GB. +44 (0) 121 552 0660...
Need help?
Do you have a question about the EALIFT and is the answer not in the manual?
Questions and answers