Related Manuals for Milwaukee MX FUEL MXF PTR2
Summary of Contents for Milwaukee MX FUEL MXF PTR2
- Page 1 OPERATOR'S MANUAL Cat. No. MXF PTR2 MX FUEL™ PIPE THREADING MACHINE W/ ONE-KEY™ WARNING To reduce the risk of injury, user must read and understand operator's manual.
-
Page 2: General Power Tool Safety Warnings
GENERAL POWER TOOL • Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left SAFETY WARNINGS attached to a rotating part of the power tool may Read all safety warnings, instruc- WARNING result in personal injury. - Page 3 Sharp cutting tools require less damage the battery and increase the risk of fire. torque and the tool is easier to control. SERVICE Only use MILWAUKEE or equivalent die • ® • Have your power tool serviced by a qualified heads.
-
Page 4: Functional Description
FUNCTIONAL DESCRIPTION 1. Hammer chucks 2. Foot switch holder 3. Accessory carriage handles 4. Carriage assembly adjuster 5. Debris tray 6. Oil reservoir 7. Battery bay 8. Cart latch 9. Cross bar 10. Cart handles 11. Cart 12. Cord holders 13. -
Page 5: Specifications
ADDITIONAL BATTERY SAFETY RULES ASSEMBLY o reduce the risk of fire, personal Recharge only with the charger WARNING WARNING injury , and product damage due to specified for the battery. For a short circuit, never immerse your tool, battery specific charging instructions, read... - Page 6 Removing/Installing Dies Wrap the foot switch cord around the cord holders and place the foot switch on top sliding into foot 1. Remove battery pack. switch holder. 2. Remove the die head. Clean the cutting chips off To collapse cart, pull to release the cart latch and the dies with a wire brush before removing from push down on the accessory carriage handles until the die head.
- Page 7 Adjusting Die Head Filling/Draining the Oil Reservoir 1. Remove battery pack. 1. Remove battery pack. 2. Loosen clamp lever. 3. Slide the pipe scale to the desired size. Over has a larger thread diameter removing more material. Under is a smaller thread diameter removing less material.
- Page 8 Removing/Installing the 6. Remove accessory carriage handles. Power Drive from the Cart When using another means of lift or device, ensure the lift sling is secure under the accessory carriage handles and accessory arms. Always lift according to sling manufacturer's instructions. Ensure the sling is in good repair and rated for the total weight of tool, any attached accessories, and oil.
-
Page 9: Operation
uses or modifying this machine for other Vertical Storage Position applications may increase the risk of serious injury. Do not use this machine without the debris tray or filter. Do not use this machine if the foot switch is broken or missing. The foot switch provides safe control of the machine, such as emergency shutoff in case of entanglement. - Page 10 c. When thread is complete, release die heads 5. Secure the pipe by turning the hammer chucks by lifting the die release lever. anticlockwise until tight. NOTE: If automatic die release mechanism is Select desired application (cutting, threading or used, then die heads will automatically release. reaming) by lowering corresponding accessory Twist the carriage assembly adjuster removing into place.
-
Page 11: Maintenance
If the machine does not start or operate at full power with a fully charged battery pack, clean the contacts on the battery pack. If the machine still does not work properly, return the machine, charger and battery pack, to a MILWAUKEE service facility for ® repairs. - Page 12 Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE ® prides itself in producing a premium quality product that is Nothing But Heavy Duty Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE ®...
Need help?
Do you have a question about the MX FUEL MXF PTR2 and is the answer not in the manual?
Questions and answers