Sony WALKMAN WM-FX401 Operating Instructions Manual

3-758-303-23 (1)B72
SONY
Radio Cassette Player
wu-FX401/FX403
aman Operating instructions aaa
WALKMAN is a trademark of Sony Corporation.
OWNER'S RECORD
The model number is located on the bottom and the
serial number is located inside the cassette holder.
Record these numbers in the spaces provided below.
Refer to them whenever you call upon your Sony
dealer regarding this product.
Model No.
Serial No.
INFORMATION
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
arcrease the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
Getting Started
Using with Batteries
Insert two AA (R6) batteries in correct polarity.
Notes
¢ When you are not going to use your Waikman for a long time,
remove the batteries to prevent damage from battery leakage and
corrosion.
When the batteries become weak, the BATT indicator will glow
faintly and the sound will be unstable or can not be heard. in such
a case, replace both batteries.
¢ Replace both batteries within 5 minutes, not to clear the memories.
Using External Power Sources
You can connect the following external power sources
through the DC IN 3 V jack located on the right side.
(When you plug a cord into the DC IN 3 V jack, the
internal batteries are automatically bypassed.)
House current using an AC-E30L AC power adaptor
©12 V car battery using a DCC-E130L car battery cord
Polarity of the plug
Note
Use only the recommended AC-E30L AC
power adaptor (not supplied). Do not use
any other AC power adaptor.