Miele Touchtronic T 9820 Operating And Installation Instructions page 44

Gas connection
Gas supply
All installation material (hoses and
adapters) must be provided by the
installer.
Gas connection distances
The gas supply line must be made of
1
/ " rigid pipe.
2
This appliance must be installed with its
own shut off valve on the gas supply
line. The valve must be within 6 ft.
(1.8 m), and in the same room, of the
dryer.
1
An / " NPT pressure tapping plug must
8
be installed immediately upstream of
the gas supply connection. This allows
the gas inlet pressure to be checked
regularly.
40
a Flare union adapter
1
b
/ " NPT pressure tapping plug
8
c Gas shut-off valve
For convenience (if allowed by code),
an AGA or CGA approved flexible
stainless steel gas hose (accordion
type) may be used between the gas
source and the dryer. This will allow the
appliance to be moved from the
installation site for cleaning or
servicing. Make sure that nothing rubs
on the gas hose.
If there is any doubt concerning
installation, contact the Miele Technical
Service Department at the phone
number listed on the back of this
manual.