Table of Contents
Advertisement
Quick Links
www.ime.de
Operating manual
Publish Date: 2023-01-30
v1.0
Wireless sensor
Operating manual
ERS2 series
ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden
E-mail:
support@elsys.se
ǀ Web:
www.elsys.se
Specifications in this document are subject to change without notice.
©ElektronikSystem i Umeå AB 2022
Advertisement
Table of Contents
Related Manuals for IME Elsys ERS2 Series
Summary of Contents for IME Elsys ERS2 Series
- Page 1 Operating manual Publish Date: 2023-01-30 v1.0 Wireless sensor Operating manual ERS2 series ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se Specifications in this document are subject to change without notice. ©ElektronikSystem i Umeå AB 2022...
- Page 2 Operating manual ERS2 series Important safety information Read this manual before attempting to install the device! Failure to observe recommendations included in this manual may be dangerous or cause a violation of the law. The manufacturer, ElektronikSystem i Umeå AB will not be held responsible for any loss or damage resulting from not following the instructions of this operating manual.
-
Page 3: Table Of Contents
Operating manual ERS2 series Contents Description ........................1 Dimensions (mm) ..................1 Label........................2 Main features of the ERS2 series ..............3 Mounting guidelines ....................4 Motion PIR......................4 Room occupancy sensor ................4 Sound level .......................4 Installation .........................5 Service and maintenance ..................6 Sensor configuration ....................7 NFC Configuration ..................7... - Page 4 Operating manual ERS2 series CO2 ........................ 13 Motion PIR..................... 13 7.5.1 PIR Lens detection pattern..............14 Room occupancy (ERS2 Eye) ..............15 7.6.1 Detailed description ................15 7.6.2 Special functions for ERS2 Eye ............15 Sound level ....................16 VOC ........................
-
Page 5: Description
Operating manual ERS2 series 1. Description The ERS2 series of sensors are universal LoRaWAN indoor climate sensors. ® The sensor measures, depending on model, temperature, humidity, light intensity, CO2-level, sound-level, volatile organic compounds (VOC), occupancy and detects motion. ERS2 is a battery-powered device and is designed to be wall-mounted. -
Page 6: Label
Operating manual ERS2 series 1.2 Label At the back of your device there is a label with an Aztec barcode containing DevEUI and sensor type. ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 7: Main Features Of The Ers2 Series
Operating manual ERS2 series 1.3 Main features of the ERS2 series • Compatible with LoRaWAN specification 1.0.4 ® • Measures ambient temperature • Measures ambient humidity • Measures light intensity* • Measures CO2 level* • Measures sound level* •... -
Page 8: Mounting Guidelines
Operating manual ERS2 series 2. Mounting guidelines Common mounting guidelines for ERS2 line of sensors: • Place the sensor in an open space on the wall, with an installation height of 1.6 meters (does not apply to ERS2 Eye, see 4.2). -
Page 9: Installation
Operating manual ERS2 series 3. Installation 1. Remove the back panel of the sensor by gently prying the tab with a small screwdriver. 2. Install the batteries. The ERS2 requires one or two AA batteries. The battery type is 3.6V Lithium Battery (ER14505). You can use one battery, but it’s recommended that you use two for best battery life. -
Page 10: Service And Maintenance
Operating manual ERS2 series 3. Mount the back panel securely to the wall with at least 2 appropriate screws, using some of the four mounting holes. Alternatively, attach the sensor with double sided adhesive tape. 4. Attach the sensor part by hinging it on the back panel. -
Page 11: Sensor Configuration
Operating manual ERS2 series 5. Sensor configuration All sensor settings can be configured via a smartphone application with NFC (Near Field Communication) or over the air via the network server and downlink data to the sensor. The sampling rate, spreading factor, encryption keys, port, and modes can be changed. -
Page 12: Over The Air Configuration
Operating manual ERS2 series 5.2 Over the air configuration All settings may be configured over the air via your LoRaWAN infrastructure. ® Please visit the support section on our webpage for more information regarding downlink protocol. 5.3 Application parameters All parameters for the “Sensor settings”... -
Page 13: Sensor Behavior
Operating manual ERS2 series 6. Sensor behavior 6.1 Sensor startup 1. When the sensor starts up it loads any configuration parameters written to the NFC chip. The sensor will then write all configuration parameters back to the NFC chip. -
Page 14: Led Indication
Operating manual ERS2 series 6.4 LED indication The LED, located in the bottom right corner, indicates different actions when the sensor is active. LED indication Action Long red blink, long green blink Sensor is starting up Short yellow blink... -
Page 15: Internal Sensors
Operating manual ERS2 series 7. Internal sensors The populated internal sensors in the ERS2 series differ between models according to the list below. ERS2 ERS2 ERS2 ERS2 ERS2 ERS2 ERS2 Lite CO2 Lite Sound Temperature Humidity Light Motion PIR... -
Page 16: Temperature
Operating manual ERS2 series 7.1 Temperature Resolution: 0.1 °C Accuracy: 0.2 °C typical, see figure 7.2 Humidity Resolution: 1 % RH Accuracy at 25 °C: ±2 % RH, see figure Accuracy of RH over temp.: See figure ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se... -
Page 17: Light
Operating manual ERS2 series 7.3 Light The light sensor sits behind the PIR lens. For correct reading, make sure it isn’t obstructed. Accuracy can depend on angle of light source. Range: 0-65535 lux Accuracy: ± 10 % or ± 10 lux, whichever is greater. -
Page 18: Pir Lens Detection Pattern
Operating manual ERS2 series 7.5.1 PIR Lens detection pattern Lens for ERS2, ERS2 CO2, ERS2 Sound and ERS2 VOC (wall mount) From side From top Lens for ERS2 Eye (ceiling mount) From side From top ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se... -
Page 19: Room Occupancy (Ers2 Eye)
Operating manual ERS2 series 7.6 Room occupancy (ERS2 Eye) The room occupancy algorithm uses both the PIR sensor and an 8x8 pixel heat map sensor. If the PIR triggers, occupancy is detected. If the PIR doesn’t trigger, the heat map is enabled, and its pattern is compared to a filtered mean value of the room. -
Page 20: Sound Level
Operating manual ERS2 series 7.7 Sound level The sound level sensor continuously measures the average and peak sound pressure level with no missing events. The analog part is always on, with a peak- hold circuit for peak level, and a mean-value filtering for average value. The digital part wakes and samples both signals every 10 s and does the final calculation before sending the data at the desired send interval. -
Page 21: Device Specifications
Operating manual ERS2 series 8. Device specifications Mechanical specifications Dimensions 76,4 x 76,4 x 22.5 mm Weight 53 – 60 g excluding batteries / 70 – 95 g (depending on model) including batteries Enclosure Plastic, PC / ABS IP rating... -
Page 22: Sensor Payload Format
Operating manual ERS2 series 9. Sensor payload format The device uses the standard ELSYS payload format. Please see the specified document on our webpage. 10. Regulations 10.1 Legal Notices All information, including, but not limited to, information regarding the features, functionality, and/or other product specification, are subject to change without notice. -
Page 23: Revision History
Operating manual ERS2 series 11. Revision History Revision Description Date ERS2 series manual 2023-01-26 created ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se...
Need help?
Do you have a question about the Elsys ERS2 Series and is the answer not in the manual?
Questions and answers