Using The Audio Settings Of Quick Setup - Onkyo TX-NR515 Instruction Manual

Note
• When the "Monitor Out" setting is set to "Sub", "Video" cannot
be selected.
*1 • The video preview is not displayed when:
– HDMI IN 5/6/7 is the current HDMI input source, or
– No signal is present on the current input source.
*2 Only when you have selected "Custom" in the "Picture
Mode" (➔ page 58), pressing ENTER allows you to adjust
the following items via the Quick Setup: "Brightness",
"Contrast", "Hue" and "Saturation". Press RETURN to
return to the "Picture Mode" setting.
*3 Depending on the input source and listening mode, not all
channels shown here output the sound.
*4
• This setting is not available in either of the following cases:
– The "Audio TV Out" setting is set to "On"
– "HDMI Control(RIHD)" is set to "On"
you're listening through your TV speakers.
Using the Audio Settings of Quick
Setup
You can change various audio settings from the Quick
(➔ page 45).
Setup
Note
• These settings are not available in either of the following cases:
– The "Audio TV Out" setting is set to "On"
– "HDMI Control(RIHD)" is set to "On"
you're listening through your TV speakers.
Tone Control
(➔ page 62).
■
Bass
(➔ page 62) and
–10dB to 0dB to +10dB in 2 dB steps
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
–10dB to 0dB to +10dB in 2 dB steps
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when Direct or Pure Audio (European, Australian
and Asian models) listening mode is selected.
Operating on the AV receiver
1
Press TONE repeatedly to select either "Bass" or
"Treble".
2
Use – and + to adjust.
(➔ page 62).
(➔ page 62) and
En-46
Advanced Operations
Speaker Levels
■
Subwoofer Level
–15dB to 0dB to +12dB in 1 dB steps
■
Center Level
–12dB to 0dB to +12dB in 1 dB steps
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
(➔ page
here, go to "Level Calibration"
setting the AV receiver to standby.
Note
• You cannot use these function while the AV receiver is muted.
• These settings cannot be used while a pair of headphones is
connected.
• Speakers that are set to "No" or "None" in
"Speaker Configuration" (➔ page 52) cannot be adjusted.
Audyssey
■
Audyssey
(➔ page
See "Audyssey" in "Source Setup"
■
Dynamic EQ
See "Dynamic EQ" in "Source Setup"
■
Dynamic Volume
See "Dynamic Volume" in "Source Setup"
Note
• These technologies can be used when all the following conditions
are met:
– Room Correction and Speaker Setup is completed. Note that
"Audyssey" requires the "Audyssey 2EQ Full Calibration"
method.
– Any listening mode other than Direct or Pure Audio
(European, Australian and Asian models) is selected.
– A pair of headphones is not connected.
• The setting is stored individually for each input selector.
53) before
55).
(➔ page 56).
(➔ page 56).