Turning On The Receiver; Turning On And Standby; Changing The Input Display - Onkyo 8555 - TX AV Receiver Instruction Manual

Turning On the Receiver

ON/STANDBY
STANDBY indicator

Turning On and Standby

1
Press the [ON/STANDBY] button.
Alternatively, press the remote
Receiver
controller's [ON/STANDBY]
button.
The receiver comes on, the display
lights up, and the STANDBY indicator
goes off.
or
Remote
controller
To turn the receiver off, press the
[ON/STANDBY] button, or press the
remote controller's [ON/STANDBY]
button. The receiver will enter Standby
mode. To prevent any loud surprises
when you next turn on the receiver,
always turn down the volume before
you turn it off.
22
ON/STANDBY

Changing the Input Display

For the TAPE and VCR/DVR buttons, the input display
name can be changed in the sequence as shown below.
When the input display name has been changed for one
of the buttons below, the display name for the other
button cannot be changed.
• TAPE button : TAPE→MD→CDR→DOCK
• VCR/DVR button : VCR/DVR→DOCK
1
Press the appropriate input
selector button.
The selected input name appears in the
or
display.
2
Press and hold down the input
selector button selected in the
Step 1 above for approximately 3
seconds to change the display
name.