Table of Contents
Advertisement
RADIO RECEPTION
Tuning into a station
1 Press TUNER ON/BAND repeatedly to select AM
or FM.
2
Press TUNING + (-)
or - (W<)
to tune into a
station.
After listening, press
STOP/OFF/CHARGE
to turn off
the radio.
For quick tuning
Keep either TUNING + (_l)
or – (W)
pressed for 1
or 2 seconds. When a station is tuned in to, the frequency
stops automatically.
However, it does not stop if the
broadcast signal is weak.
For better reception +
~
FM: The headphone cord functions as the FM antenna.
Keep it extended.
AM: Turn the unit to find the position which gives the
best reception.
To listen to an FM stereo broadcasting
Press MONO/ST repeatedly to display STEREO.
When the FM stereo signal is weak and distorted, press
MONO/ST
again. STEREO display goes out and the
sound will be heard in monaural but distortion will be
reduced.
Note
Do not open the disc compartment
during
radio
reception. The buttons will be deactivated.
The power is turned off automatically
if no operation is
made after 3 hours from the last operation during radio
reception.
AM/FM steps +
O
Radio broadcasts have different frequency ranges and
changes in different steps in different countries.
This unit is factory-set to 10 kHz steps on AM. When
using the unit where the AM step changes 9 kHz, set
the AM STEP switch in the battery compartment
to
9 kHz.
Advertisement
Table of Contents
