Philio Technology Corporation PST12 Quick Start Manual

Window + flood water sensor

Advertisement

PST12 Window + Flood Water Sensor
PST12 not only has door/window sensor but also has flood sensor,
based on Z-Wave
TM
technology. It is the Z-Wave
support the security, OTA... Those newest features of the Z-Wave
technology. Z-Wave
TM
is a wireless communication protocol designed
for home automation, specifically to remotely control applications in
residential and light commercial environments. The technology uses a
low-power RF radio embedded or retrofitted into home electronics
devices and systems, such as lighting, home access control,
entertainment systems and household appliances.
This product can be included and operated in any Z-Wave
with other Z-Wave
TM
certified devices from other manufacturers and/or
other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the
network.
The device adopt the Z-Wave
network system is all made by Z-Wave
network system will have the advantages as below.
Function Compare A/B/C
Specification
Rated
Battery life
TM
plus product, it
RF distance
TM
RF Frequency
RF Maximum Power
Dimension
Location
Operation temperature -20
TM
network
Humidity
FCC ID
Specifications are subject to change and improvement without notice.
1
TM
800 series chip, when your Z-Wave
Concurrent multi-channel support reduces external interference.
Better RF range, improve about 10 meters in indoor.
Support 100 Kbps transmit speed, speed up communication.
Flood
PST12-A
V
PST12-B
V
PST12-C
3VDC (CR123A lithium battery)
20 years
Min. 40M indoor,
100M outdoor line of sight,
868.40 MHz, 869.85 MHz(EU)
908.40 MHz, 916.00 MHz(US)
920.9MHz, 921.7MHz, 923.1MHz
(TW/KR/Thai/SG)
+10dBm (Peak), -10dBm (Average)
85(L)x28(W)x23(H)mm
indoor use only
o
C to 50
o
85%RH max
RHHPST12
TM
800 series devices. The
Magnetic
V
V
C
TM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PST12 and is the answer not in the manual?

Questions and answers

Summary of Contents for Philio Technology Corporation PST12

  • Page 1 PST12-C Specification Rated 3VDC (CR123A lithium battery) Battery life 20 years PST12 not only has door/window sensor but also has flood sensor, Min. 40M indoor, based on Z-Wave technology. It is the Z-Wave plus product, it RF distance 100M outdoor line of sight, support the security, OTA...
  • Page 2: Troubleshooting

    Indication of battery life : Alarm Report Window/Door: 60 times/Day,  Auto Report: 4 times/Day, Auto Wake up 1 time/Day. Flood Alarm  Report:1 times/month, Auto Report: 4 times/ Day, Auto Wake up 1 time/ Day. Troubleshooting Symptom Cause of Failure Recommendation The device can not The device may in a Z-...
  • Page 3: Function Description

    Add to/Remove from Z-Wave Network CAUTION – replacement of a battery with an incorrect type that can defeat a There are two tamper keys in the device, one is in the back side, safeguard (for example, in the case of some lithium battery types); another is in the front side.
  • Page 4 2. Pressing the tamper key three times within 1.5 *notice1:The QR code can be found on the device seconds to enter the inclusion mode. PST12 or on the box. 3. After add successful, the LED will light ON 1 This machine provides two groups of nodes.
  • Page 5: Power Up Procedure

    Z-Wave Message Report * Tamper Report: The tamper key pressed over 5 seconds. The device will into the alarm In default the device will using Notification Report to represent the state. In that state, if the tamper key be released, the device will tamper trigger、...
  • Page 6: Installation

    three times. Please change another new battery. Installation * Wake When the device power on, the device will wake about 20 seconds. In this duration, the controller can communicate with the device. Normally 1. To mount the device on the wall, you can choose using the tape, or the device is always sleeping to save the battery energy.
  • Page 7: Z-Wave Configuration Settings

    mode. You will see the LED light ON one second. (refer to fig. 1) Warning: 2. Let the controller associate with the device into the first group, any 1. Before the product is installed, please make sure the surface is clean. light switch that intend to be turned on when the device trig please Especially for the surface of glass and wood, keep it dry before associate with the device into the second group.
  • Page 8 Vali Vali Name A B C Description Name A B C Description 0 : Disable / 1 : Enable Auto Report The interval time for auto report    Bit1: Disable auto report Flood the flood state.    door/window function.
  • Page 9: Fcc Interference Statement

    They can take this product for operate this equipment. environmental safe recycling. This transmitter must not be co-located or operating in conjunction Philio Technology Corporation with any other antenna or transmitter. 8F., No.653-2, Zhongzheng Rd., Xinzhuang Dist., New Taipei City 24257, Taiwan(R.O.C) www.philio-tech.com...

This manual is also suitable for:

Pst12-aPst12-bPst12-c

Table of Contents