Advertisement

Instruction Manual
Selina
After installation please store instructions for future reference

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Selina and is the answer not in the manual?

Questions and answers

Summary of Contents for Carson Selina

  • Page 1 Instruction Manual Selina After installation please store instructions for future reference...
  • Page 2: Tools Required

    Tools required  Warning Read and follow all instructions and warnings in this manual. Keep future reference. Ignore the safety warnings may lead to injuries and/or damaging the product. Please contact your local dealer for repairs or maintenance. Please contact our company if you have any further questions.
  • Page 3: Troubleshooting

    Trouble shooting Initially, there may be some wrinkles in the screen. If there are, do not worry. Let the screen sit for a few days and the wrinkles will most likely come out on their own. If they don’t, get a hair dryer. Do not use a heat or laminating gun.
  • Page 4 Install the support bars and screen material Remove the screen material and ensure the front side is facing downward. Place it at the center of the frame and unfold it. Align the holes in the strut bar precisely with the holes in the frame, then tighten a screw to secure them.
  • Page 5 Install the support bars and screen material (continue) Attach one end of the spring to the frame slot. Then, use a wire retractor to connect the other end of the spring to the PVC pole. Begin by securing the eight springs at the four corners first, and then attach the remaining springs.
  • Page 6 Hang screen on the wall Measure the height of “A” and the width of “B”. Screw the upper brackets to the wall , the distance between the two brackets is “B” minus around 1000mm or 40 inches, Make sure all the brackets are secured to studs.
  • Page 7 Hang screen on the wall (continue) Diagram of the back Hang up the frame on the upper brackets. Take out the lower connecting plate. Gently lift the bottom of the screen and use the lower connecting plate to hook it into the slot on the frame. Tighten a screw to complete the installation.
  • Page 8: Part List

    Part list PVC poles Spring hook Sleeve anchors Connected plates Wall plugs Springs M5 screws Connectors Splice bars screws Lower connecing plates Frames enquiry@carsonscreens.com.au | carsonscreens.com.au | Unit 2, 68-72 Derby Street SILVERWATER 2128 NSW Australia © Carson Screens 2023 2023-10-23...

Table of Contents