Tubular motors Type 15 W and 15 W NMA Installation instructions (translation) ● For the safety of persons it is important to follow these installation instructions! ● These instructions are intended for the fi tter, the electrician and the user.
GmbH assumes no liability for personal injuries, property damages and financial losses that arise from non- observance of the installation instructions. Liability for material defects is excluded in such cases.
Page 3
● Never hammer the drive as this will damage the bearings and housings. ● Use original elero parts only. ● If the drive is opened without permission or used in an improper manner, or if it is incorrectly installed or operated, there is a risk of damage to persons and property.
Page 4
1.7 Intended use Doors which are fitted with an elero rolling door drive The tubular motors Type 15 W and Type 15 W NMA are and operated with an elero control system, have to intended exclusively for roller shutters, awnings and have the legally prescribed accessories for safe opera- rolling doors.
2. Scope of supply 3. Installation 2. Scope of supply Drive version Type 15/...W Type 15/...W NMA Circlip 60 x 2 DIN 471 ● ● Key 7 x 8 x 22 DIN 6885 ● ● Hex socket countersunk screw M8 x 16 DIN 7991 ●...
3. Installation Lifting capacity chart 3.4 Lifting capacity chart (kg) for one-piece roller shutters and rolling doors Type Rated torque Shaft Nom. bar Rolling door / roller shutter height up to Ø thickness 2.0 m 2.5 m 3.0 m 3.5 m 4.0 m 4.5 m 5.0 m...
If the limit position is not NMA limit switch reached, lower the roller shutter and repeat the procedure Capacitor (only in Type 15 W NMA) as described above. Operating limit switch Setting of the "Down" direction Switch on the drive in the "Down"...
3. Installation Installation and mounting STOP! ● The fi tter has to check the solidity of the masonry etc. before installing the system. ● The fi xing plates of the Type 15 tubular motors are not oscillating and must be attached at right angles without tension to the fi...
4. Manual operation CAUTION! Observe the following safety instructions. Failure to observe them can lead to bodily injuries! ● Switch off the circuit breaker (main switch) before manual operation. ● The manual operation is only needie for operating the door, awning, roller shutter etc. in an emergency, e.g.
Repair the system. object. Guide rail damaged. 5.2 Notes on repair Repair address Please contact us if you are unable to eliminate a elero GmbH problem: Antriebstechnik Please supply the following information when con- Linsenhofer Straße 65 sulting our service team: D-72660 Beuren –...
• DIN EN 12604:2000 • DIN EN 14202:2004 • DIN EN 13561:2004 Beuren, 14.10.2011 Ulrich Seeker -CE-Beauftragter-, -Doku-Bevollmächtigter- elero GmbH Linsenhofer Straße 65 Fon: +49 (0) 7025 13-01 info@elero.de We reserve the right to make technical changes Antriebstechnik D-72660 Beuren Fax: +49 (0) 7025 13-212 www.elero.com...
Need help?
Do you have a question about the 15 W and is the answer not in the manual?
Questions and answers