Table of Contents
Advertisement
Connect the speaker cables.
≥ Insert the wire fully, taking care not to insert beyond the wire insulation.
Drive a screw into the wall.
≥ Use the measurements indicated below to identify the screwing positions on the wall.
≥ Leave at least 20 mm (
/
25
speaker.
≥ The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg
(72.8 lbs).
≥ Keep the screws out of reach of children to prevent swallowing.
Fit the speaker(s) securely onto the screw(s).
≥ Place the speaker that is connected with the speaker cable with a red connector on the observers' right, and connect with
the speaker cable with a white connector on the observers' left.
White
J WHITE: Left speaker channel (L)
≥ Move the speaker so that the screw is in this
position.
Push
q) of space above and on each side of the speaker to allow enough space for fitting the
32
A At least 30 mm (1
B ‰4.0 mm (
/
5
q)
32
C ‰7.0 mm to ‰9.4 mm
(
/
q to
/
9
3
q)
32
8
D Wall or pillar
E 5.5 mm to 6.5 mm
(
/
q to
/
7
1
q)
32
4
DO
1 Insert the wire fully.
r: White
s: Blue line
2 Press into the groove.
/
q)
3
16
Red
K RED: Right speaker channel (R)
≥ In this position, the speaker will likely fall if moved to
the left or right.
F Front speaker
(Rear view)
G 102 mm (4
H 37 mm (1
15
I Wall mounting
hole
DO NOT
RQT9660
/
1
q)
32
/
q)
32
13
Advertisement
Table of Contents
