Subscribe to Our Youtube Channel
Related Manuals for Xerox KC-300
Summary of Contents for Xerox KC-300
- Page 1 10/100BASE-TX TO 100BASE-FX MEDIA CONVERTERS KC-300 Ver.B Installation Guide P/N 750-0165-000 DOC.020730-KC300B-K...
-
Page 2: Table Of Contents
The information contained in this document is subject to change without prior notice. Copyright ã All Rights Reserved. TRADEMARKS Ethernet is a registered trademark of Xerox Corp. FCC NOTICE This device complies with Class B Part 15 the FCC Rules. Operation is... -
Page 3: Introduction
1. Introduction The 10/100BASE-TX to 100BASE-FX media converter series provides a media conversion allowing high-speed integration of fiber optic and twisted-pair segments. With 10BASE-T and 100BASE-TX support, the converters provide seamless translation between Ethernet and Fast Eth- ernet networks. A complete set of LEDs allows for quick status verifica- tion. -
Page 4: Specifications
1.1 Specifications Twisted-Pair Interface Connector Shielded RJ-45 Pin Assignments Auto MDI/MDI-X detection Compliance IEEE 802.3 10BASE-T, 802.3u 100BASE-TX Data Speed 10Mbps or 100Mbps Duplex Mode Half-duplex or Full-duplex Cable Type 10Mbps - Category 3, 4, or 5 UTP 100Mbps - Category 5 UTP Supported Link Length 100 meters Fiber Optic Interface... -
Page 5: Installation
2. Installation 2.1 Unpacking Check that the following components have been included: • Installation guide • 10/100 Media Converter • One AC power adapter for the converter 2.2 10/100 Media Converters Functions of UTP Port (Twisted-Pair Interface) • Auto-negotiation support for connecting to auto-negotiation devices •... -
Page 6: Led Indicators
Functions of 100BASE-FX Port (Fiber Optic Interface) • Full data rate of 100Mbps for remote fiber connection • Fixed full-duplex operation • IEEE 802.3x compliant (pause-frame-base) flow control for full- duplex operation Model Fiber Wavelength 300/TFMT Duplex MM 2 ST 1310nm 300/TFMC Duplex MM 2 SC... -
Page 7: Applying Power
2.4 Applying Power Before you begin the installation, check the AC voltage of your area. The AC power adapter which is used to supply the DC power for the unit should have the AC voltage matching the commercial power voltage in your area. The AC Power Adapter Specifications AC input power: AC power voltage of your area... -
Page 8: Making Fiber Connection
3. Making Fiber Connection 3.1 Making Duplex Fiber Connection The following figure illustrates how to make connection between two media converters with duplex fiber cables. 3.2 Making Single Fiber Connection Since the single fiber media converters use different wavelengths for transmission and receiving respectively, the link partner device located on the remote end of the single fiber should match the wavelength used on the single fiber converter.
Need help?
Do you have a question about the KC-300 and is the answer not in the manual?
Questions and answers