Safety Instructions And Precautions - UNI-T UT25CL User Manual

UT25CL User Manual
CAT III

3.2 Safety Instructions and Precautions

Warning: To avoid electric shock, fire or personal injury, please read through the user manual.
• After reading the "Safety Information", please keep it and the user manual along with the Meter in
a proper place for future use.
• To ensure safe use, the user must adhere to the safety instructions and warning affixed to the
product. Failure to follow the operating instructions may compromise or lose the protection provided
by the Meter.
• Please check the Meter and the test leads before use. The insulation of the test lead shall not be
damaged or broken. If the test lead is damaged, please replace it immediately (The rated voltage,
frequency and type of the replacement leads must be same with that of the Meter). Use only test
leads approved by safety certification body.
• If any problem is found, such as bare test lead, damaged casing, abnormal display, damaged
accessory, etc., please stop use immediately and prevent inadvertent use.
• For safety, please do not alter the internal wiring of the Meter to avoid damaging the Meter and
posing safety risks.
• Do not use or keep the Meter in places with high temperature and high humidity. If the Meter gets
damped, its performance may degrade.
• It is forbidden to use the Meter without the cover closed well, otherwise it may present a risk of
electric shock.
• Please ensure the user's hands, shoes, clothing, ground, circuits and components are dry.
• When the Meter is performing measurement, please do not make contact with the bare wire,
connector, unused input terminal or circuit under testing.
• Use caution when working with voltage over 30V (DC/AC), please grip the test lead behind the
finger guard to avoid electric shock.
Conform to European Union
standards
Do not place equipment and its accessories in the trash. Please dispose
properly according to the local regulation.
Applicable to test and measure the circuit connected with the power
distribution part of building's low-voltage MAINS installation.
UKCA certification mark
6