Washer Operating Procedure - Haier HWF 5000 AW User Manual

English
7) Custom Program
selections have been made press the "Custom Program" button. To use setting again
on a later wash, go to your selected cycle and press the "Custom Program" button and
the washer with automatically go to the saved setting. When in stand by status set all
washing selections (except delay start). Press&hold the custom pad for 3 seconds to store.
A maximum of 10 custom programs can be stored. One for each cycle.
8) Extra Rinse
9) Stain Treat
clothes.
10) Prewash
wash. This is available in "White"; "Heavy Duty" "Normal" and "Perm Press" Cycle.
11) Beeper (Signal)
of cycles or options, and when wash cycle is completed. At the end of the cycle the unit
will sound 3 beeps. If function is available with a cycle selection, the signal will sound one
short beep when selected. If function is not available with a cycle 2 short beeps will sound
when pad is press.A signal will sound every 10 minutes upon completion of a cycle to
remind you to remove the load.
12) Delay
the delay button. Each press of this button can increase delay time in 30 minute segments.
cancel once set, press the Start / Pause button. When delay time flashes press power
button to shut off washer.
13) Water Temperature (Wash / Rinse)
are not available in all cycles. Follow fabric care labels for best results.
14) Spin Speed
change the preprogrammed selection. Selections may vary by cycle chosen. All selections
are not available in all cycles. Certain clothes are not recommended to be spun at high
speeds. Please see clothes manufacturor recomendation for best results.
15) Soil Level
soil level in clothes. The dirtier the clothes the heavier the level.

Washer Operating Procedure:

1. Press the Power button to power on the washer.
2. Select wash cycle by rotate the knob. the cycle name will illuminate.
3. Once selection is made, the soil level, spin speed, and the wash/rinse water
temperatures are pre-set. At this time, you can change options. Press the start/pause
button to start the wash cycle. Option selecctions should be made prior to pressing the
Start / Pause button.
13