Haier HW-07LM03 - annexe 1 Operation Manual

ROOM AIR COMNDITIONER
HW07M HW09M
HW12M HW18M
Please read this operation manual before using the air conditioner
Please keep it attentively
0010517091
CONTENTS
Safety precautions...................1
Air conditioner operation..........2
Care and Maintenance ............4
Air conditioner installation........5
Troubleshooting.......................7
1
SAFETY PRECAUTION
Do not install,remove and reinstall the unit yourself.
leakage,electric shock or fire.Please engage an authorized dealer or specialist for the installation work.
The room air conditioner must be earthed.
Do not touch or operate with wet hands.
Do not turn on the unit by inserting the power plug.Do not switch off the unit by pulling out
the power plug.
Do not insert sticks,fingers or other objects into the unit.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similar qualified person.
After installation, the power plug should be easily reached.
The wiring method should be in line with the local wiring standard.
OPERATION CONDITIONS
Applicable ambient temperature range:
Indoor
Cooling
W.B
D.B
o o
32 C 23 C
Max.Temperture:
Min.Temperture: o o
18 C 14 C
2
AIR CONDITIONER OPERATION
PART INDENTIFICATION
Machine body
Front panel
Air inlet
(indoor side)
Air filter (inside)
Operation
panel
Ventilation
Power plug
2
Air filter cleaning
When dirt accumulates on air filter, air
circulation will be blocked, which causes
poor cooling. It is advisable to clean air
filter every two weeks for longer operation.
Take out the air filter
1.Press the concave parts on
both sides at the lower part of
air inlet grille to open the air
inlet grille.
°
70
2.Hold the hump of filter mesh
with fingers (as illustrated) and
take it out.
Hump
Clean the filter
1.Gently flap the dirt off the air filter.
2.Carefully wash air filter in warm water(below 40°C To
obtain better cleaning effect,soap water or neutral detergent
may be used.
3.Flush air filter carefully with clean water after removing
dirt.Let it dry completely.
OPERATION MANUAL
CAUTION
Improper installation may cause
Outdoor
D.B W.B
o o
43 C 26 C
D.B :Dry Bulb Temperature
o
18 C /
W.B :Wet Bulb Temperature
Air outlet
1
Ventilation
(indoor side)
Machine body
CLOSE
The ventilation lever must be
CLOSE position in order to
maintain the best cooling
conditions. When fresh air is
necessary in the room, set the
ventilation lever to the OPEN
position. The damper is
Air inlet
opened and room air is
(outdoor side)
exhausted.
3
Airflow Direction
CAUTION
Before cleaning, turn off
the power
Airflow Direction Vane
Do not raise the front panel
The Vertical Airflow Direction
any higher than 70° to the
Vane is manually controlled
unit or damage to the tabs
by positioning the vane to
may occur.
discharge the air
upward,downward or straight
out.
Vertical
airflow direction
The horizontal air direction is
adjusted by setting the
AUTO SWING switch to the
ON position.
Operation panel
1
Auto swing switch
HW07M
2
Thermostat switch
This switch controls the preset indoor
temperature to make the air conditioner
start or stop automatically, so as to reduce
power consumption and operate the
system both comfortably and economi-
cally.
The compressor stops running when the
set temperature is reached but the fan
continues to operate to keep an even
indoor temperature.
Note:
It is advisable not to keep
mode,otherwise , condensate water might occur.
Don't move the vertical
AUTO SWING switch
1 3
2
4
3
CARE AND MAINTENANCE
Always turn off the air conditioner and the main power supply before clean the unit.
Switch off the power supply if the unit is not going to be used for a long period of time.
1
Air filter cleaning
It is advisable to clean air filter every two weeks for
longer operation.
(You will find how to clean the filter on page 2 .)
OPEN
2
Notes
Avoid opening doors and windows
unless necessary.
Use curtain or blind
Direct sunlight may reduce cooling
effect, always use window curtain.
Don't hang clothes in the vicinity
of air inlet. This will decrease
cooling effect and cause abnormal
operation.
Switch off the breaker and set the main
control knob to the off position before
plugging the power plug into an electrial
outlet.
In cooling mode, after you turn
thermostat switch counter-clockwise,do
not turn it back until at least 3 minutes
have elapsed.Otherwise, the fuse may
blow due to overload.
Do not exceed the selection range.
4
3
2
1
HW09M HW12M
3
Mode selection switch
horizontal flap at downward position for a long time in COOLor FAN
flap with hand in order to avoid the vertical flap abnormal, using the
to adjust the move of vertical flap.
Don't be exposed to cold air for
a long time.
Keep heat source away from
air conditioner.
Temperature should be set properly
when there are infant,child, the
aged or disabled in the room.
Baby has
gone sleep,
better to adjust
suitable temp.
CAUTION
6
5
7
8
9
10
HW18M
Cleaning of the
air filter
Set temp . a little bit higher
before going to bed.
Proper
temperature
After unit stops, don't restart it
until 3 min. have elapsed.
OK! Enjoy a
3-min nap
Before operating mode
selection switch, check that if
the air inlet or outlet have been
blocked.