Table of Contents
Advertisement
Operation
Display board
Remote controller
PURIFY
FRESH
POWER/SOFT
1.Unit start
Press ON/OFF on the remote controller, unit starts.
2.Health anion function
Press Purify button.
controller and
board . Air conditioner starts air ionization purify and
health anion function operation.
For twice press,
3.Change-for-fresh-air function
Press FRESH button , "
controller and the change-for-fresh-air function operation begins.
For twice press , the display " "disappears and the
change-for-fresh-air function operation is canceled
note：If the unit didn't install change-for-fresh-air electrical engine,
change-for-fresh-air function is not available.
When indoor fan motor is running, it has healthy
process function. (It's available under any mode)
When the fan in the indoor unit does not work, the health lamp
lights up, but the anion generator does not release anion.
BRIEF INTRODUCTION TO AIR IONIZATION PURIFY AND
HEALTH ANION FUCTION
1.The anion generator in the air conditioner can generate
a lot of anion effectively balance the quantity of position
and anion in the air and also to kill bacteria and speed up
the dust sediment in the room and finally clean the air in
the room.
2.The purification function of AIP:
DC high voltage bring high voltage electrostatic field, which
ionize air into positive and negative ion.
positive and negative ion adhere to dust passing by, so the
dust become "particle with electric charge".
passing by adheres to the AIP board under the force from
the electric field, which purifies the unit.
3.When power off, press the purify button, the Remote
controller shows "FAN, low, AIP, and negative ion", and
the TIMER function is available.
4.About change-for-fresh-air function
1)After the change-for-fresh-air function is initiated, the outside air can
enter the indoors through the change-for-fresh-air tube thereby
keeping the indoor air fresh.
2)Setting the change-for-fresh-air function under the shutdown status:
Under shutdown status, press the fresh air key and the remote
controller displays the on status of air flow, low wind, and change-
for-fresh-air functions, and now can set the timing open, timing
close and time control switch. Press on-off button to cancel the
change-for-fresh-air function.
8
HEALTH operation
is displayed on the remote
is displayed on the display
and
disappear,the operation stops.
"displayed on the remote
a great deal of
so the dust
Advertisement
Table of Contents
