SAL SWL10L Quick Start Manual

1. Foreword
IMPORTANT: IN THE INTEREST OF PRODUCT PERFORMANCE AND SAFETY PLEASE READ THESE GUIDE AND WARRANTY INSTRUCTIONS BEFORE INSTALLING THE PRODUCT.
DIY SAL products are designed in accordance with all mandatory International and Australian Standards, which require installation in accordance with
AS/NZS3000 by a qualified installer and regular cleaning and maintenance of the equipment. Products are sold in accordance with the following
instructions and SAL standard terms and conditions of sale, available via www.sal.net.au.
Due to continued product and information updates, product data sourced from sal.net.au shall not form part of any contract and or technical performance
guarantee unless expressly confirmed in writing by SAL at the time of order.The product wireframe drawings in this document are intended for illustration purposes
only and may differ from the final physical product. The installation instruction is subject to change without prior notice.
2. Product Introduction
SAL Push Button Switch is a mechanical push button ON/OFF switch,
with different wiring options to turn on/off its LED indicator.
2.1 Product Features
• Fits most branded switch plates
• Fits 1 to 6 gang wall plate installation
• Same look as PIXIE smart switches under PIXIE ambience cover plate
• Blue LED indicator can be enabled and disabled
• 10AX load rating
2.2 The package includes
• Push Button Switch * 1
• Extra key caps * 2
• Quick Start Guide * 1
3. Specifications
Model No. Input (V)/(Hz)
SWL10L
250/50
4. Wiring and Installation
4.1 LED indicator permanently on
(neutral required at switch for LED indicator)
NEUTRAL
ACTIVE
4.3 LED indicator permanently on, off when switch on
(no neutral required)
NEUTRAL
ACTIVE
Quick Start Guide
Push Button Switch
SWL10L
Load rating
10AX
Light fitting
(Load)
LED
Indicator
Light fitting
(Load)
LED
Indicator
2.3 Product illustration*
PIXIE Ambience key cap
(Interchangeable)
*All drawings shown are for illustration purpose only, actual product may vary
due to product enhancement.
IP Colour Dimension L x W x H (mm)
20 White
4.2 LED indicator off permanently, on when switch on
(neutral required at switch for LED indicator)
NEUTRAL
ACTIVE
4.4 LED indicator on permanently, off when switch on
(neutral required at switch for LED indicator)
NEUTRAL
ACTIVE
Version
Date 31/07/2023
LED indicator
Wireless
42 x 22 x 22 N/A
Light fitting
(Load)
LED
Indicator
Light fitting
(Load)
LED
Indicator
2.0