Pioneer PD-4500 Operating Instructions Manual

COMPACT DISC PLAYER
PD-5500
PD-4550
PLD-4500
PD-4501
DIGITAL AUDIO
'Opéra ting —
Instruc: tions
PD-5500
PD-4550
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown
in the explanatory drawings. However, the method of con
necting ard operating the unit is the same,
WARNING 10 prevent FIRE OR SHOCK Haz-
ARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE,
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel, Please write this serial number on your enclosed war-
*ranty card and keep it in a secure area. This is for your
security
[For Canadian model]
CAUTION: 10 prevent eLectric SHOCK DO
NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.
ATTENTION:rour prevenia Les cHocs
ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR UNE PRISE DE COURANT OU
UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES
PEUVENT ETRE INSEREES A FOND SANS EN LAISSER
AUCUNE PARTIE A DECOUVERT.
3 sada ara
This ineoduen. Complies with the Radio interference require H
ments of the E€ European Sommunty Directive 87/30B/EEC.
>
dQ PIONEER'
ITCH !S SECONDARY CONNECTED AND "|
THEREFORE
DOES NOT SEPARATE
THE UNIT FROM
MAINS
|
| _POWER IN STANDBY POSITION. {|
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Austra-
lian models are not provided with this switch,
Mains voltages in Saudi Arabia are 127V and 220V
only. Never use this model with 110V setting in
Saudi Arabia
The line voltage selector switch is located on the rear
panel of this player. Before your player is shipped from
the factory, the switch is set to the power require-
ments of the player's destination. Check that it is set
properly before plugging the power cord into the out-
let. If the voltage is not properly set or if you move
to an area where the voltage requirements differ, ad-
just the selector switch as follows:
*« Use a medium-sized (flat-blade}) screwdriver. insert
the tip of the screwdriver into the groove of the
selector switch and turn it so that the power vol-
tage marking of your area points to the arrow.
VOLTAGE SELECTOR
'The future of sound and vision.