Easily-Demount Cleaning Of Indoor Unit - Haier HSU-09RR03/R2 - annexe 2 Installation Manual

1. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar
qualified person. The type of connecting wire is H05RN-F or H07RN-F.
2. If the fuse on PC board is broken please change it with the type of T. 3.15A/250V.
3. The wiring method should be in line with the local wiring standard.
4. After installation, the power plug should be easily reached.
Indoor unit
Connecting wiring :
Power cable
: 3G1.5mm
5.Installation instruction on the indoor part of the fresh air device
Two ways for the installation of indoor part, as illustrated:
Way One (right direction): Take off the lid for right piping pipe,put the Outlet joint into the lid,then put the fresh air tube
Way Two (left direction): Take off the lid for leftt piping pipe,put the Outlet joint into the lid,then put the fresh air tube
Outlet joint
Lid for under piping
Fix with adhesive tape
Change for fresh air tube

5.Easily-demount cleaning of indoor unit

1.Top inlet can be taken down
Open the inlet grille, press the claw of the clip on the unit,then
take down the top inlet.(according to figure 1)
2.Horizontal flap can be taken down
Overturn the horizontal flap, press the claw of the clip ,then take
down horizontal flap.(according to figure 2)
3. Vertical louvers can be taken down
After taking down horizontal flap.vertical louvers are appeared,
draw the middle louver,and take down the horizontal louvers .
(according to figure 3)
Indoor unit
Outdoor unit
3G1.5mm 2 + 2x0.75mm
2
into the outlet jont.
into the outlet jont.
Drain hose
connection line for
air exchange
reconnection for
terminal block
2
Lid for left piping
air exchange box
connection zero line
for outdoor unit
claw of the clip
Figure 1
Daff Figure 2
Figure 3