Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. INSTALLATION....................5 4. PRODUCT DESCRIPTION................7 5.
Page 3
• Children of less than 3 years of age should be kept away from the appliance unless continuously supervised. • Children should be supervised to ensure that they do not play with the appliance. • Keep detergents away from children. •...
• If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused.
parts related to door assemblies, printed WARNING! circuit boards, electronic displays, pressure switches, thermostats and Dangerous voltage. sensors, software and firmware including reset software. The following spare parts 2.4 Use are available for at least 10 years after the • Do not put flammable products or items model has been discontinued: door hinge that are wet with flammable products in, and seals, other seals, spray arms, drain...
Page 6
Authorized Service Centre to replace it with www.youtube.com/electrolux the new one. www.youtube.com/aeg How to install your AEG/Electrolux 60 cm Sliding Door Dishwasher min. 560 1240 3.2 Safety caps If the furniture panel is not installed, open the appliance door carefully to avoid the risk of injury.
4. PRODUCT DESCRIPTION Ceiling spray arm Rinse aid dispenser Upper spray arm Detergent dispenser Lower spray arm Lower basket Filters Upper basket Rating plate Cutlery drawer Salt container Air vent 4.1 Beam-on-Floor • The red light flashes when the appliance has a malfunction.
5. CONTROL PANEL On/Off button / Reset button Option buttons (EXTRAS) Delay start button AUTO Sense program button Display MY TIME program selection bar 5.1 Display 5.2 ECOMETER The ECOMETER indicates how the programme selection impacts energy and water consumption. The more bars are on, the lower the consumption is.
6. PROGRAMME SELECTION 6.1 MY TIME The appliance senses the degree of soil and the amount of dishes in the baskets. It adjusts MY TIME selection bar allows to select a the temperature and quantity of water as well suitable dishwashing cycle based on as the wash duration.
Page 10
6.4 Programmes overview Programme Dishwasher Degree of Programme phases EXTRAS load soil Quick Crockery, cutlery Fresh • Dishwashing 50 °C • ExtraPower • Intermediate rinse • GlassCare • Final rinse 45 °C • AirDry Crockery, cutlery Fresh, lightly • Dishwashing 60 °C •...
Consumption values Water (l) Energy (kWh) Duration (min) Programme 1)2) Quick 11.0 0.620 11.8 0.970 1h 30min 11.9 1.110 2h 40min 11.9 1.210 10.9 0.542 AUTO Sense 12.1 1.220 Machine Care 10.6 0.710 The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of dishes and the degree of soil can change the values.
Page 12
The order of the basic settings presented in How to change a setting the table is also the order of the settings on the ECOMETER: Make sure the appliance is in setting mode. 1. Use Previous or Next to select the bar of the ECOMETER dedicated to the desired setting.
Page 14
Each performed softener rinse (possible more than one in the same cycle) may prolong the programme duration by another 5 minutes when it occurs at any point at the beginning or in the middle of a programme. All the consumption values mentioned in this section are determined in line with the currently applicable standard in laboratory conditions with water hardness...
is then selected automatically after you When the latest programme selection is activate the appliance. disabled, the default programme is ECO. 8. BEFORE FIRST USE 1. Make sure that the current level of the 4. Carefully shake the funnel by its handle to water softener agrees with the get the last granules inside.
4. Close the lid. Make sure that the lid locks CAUTION! into position. Only use rinse aid designed specifically for dishwashers. Fill the rinse aid dispenser when the 1. Open the lid (C). indicator (A) is clear. 2. Fill the dispenser (B) until the rinse aid reaches the marking ''MAX''.
Page 17
2. Press the button dedicated to the option During the countdown, you cannot change you want to activate. the delay time and the programme selection. • The light related to the button is on. When the countdown is complete, the •...
• When the programme is completed. • After 5 minutes if a programme was not started. If the door is opened for more than 30 seconds during the drying phase, the 9.10 End of the programme running programme ends. It does not happen if the door is opened by the When the programme is complete, the AirDry function.
Page 19
softened water results in detergent • The programme is suitable to the type of residues on the dishes. Adjust the amount load and the degree of soil. of detergent based on the water hardness. • The correct quantity of detergent is used. Refer to the instructions on the detergent 10.5 Loading the baskets packaging.
11. CARE AND CLEANING 11.2 Internal cleaning WARNING! • Clean the appliance interior with a soft Before any maintenance other than damp cloth. running the programme Machine Care, • Do not use abrasive products, abrasive deactivate the appliance and disconnect cleaning pads, sharp tools, strong the mains plug from the main socket.
Page 21
5. Make sure that there are no residues of food or soil in or around the edge of the 1. Turn the filter (B) counterclockwise and sump. remove it. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides.
Page 22
CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.6 Cleaning the lower spray arm We recommend to clean the lower spray arm regularly to prevent soil from clogging the holes. Clogged holes can cause unsatisfactory washing results.
Page 23
4. To install the spray arm back, press the spray arm upwards and simultaneously turn it counterclockwise until it locks into place. 2. Move the upper basket to the lowest level to reach the spray arm more easily. 3. To detach the spray arm (C) from the 11.8 Cleaning the ceiling spray arm delivery tube (A), turn the mounting element (B) counterclockwise and pull the...
12. TROUBLESHOOTING Refer to the below table for information on WARNING! possible problems. Improper repair of the appliance may With some problems, the display shows an pose a danger to the safety of the user. alarm code. Any repairs must be performed by qualified personnel.
Page 25
Problem and alarm code Possible cause and solution Technical malfunction of the appli‐ • Switch the appliance off and on. ance. The display shows iC0 or iC3. The level of water inside the appli‐ • Switch the appliance off and on. ance is too high.
Page 26
Before checking the PNC, make sure the WARNING! appliance is in the programme selection. We do not recommend using the 1. Press and hold simultaneously appliance until the problem has been completely fixed. Unplug the appliance for about 3 seconds. and do not plug it in again until you are The display shows the PNC of your certain that it operates correctly.
Problem Possible cause and solution Unusual foam during washing. • Use the detergent designed specifically for dishwashers. • Use a detergent from a different manufacturer. • Do not pre-rinse dishes under running water. Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener".
Voltage (V) 200 - 240 Electrical connection Frequency (Hz) 50 - 60 Water supply pressure Min. / max. MPa (bar) 0.05 (0.5) / 1 (10) Water supply min. 5 - max. 60 °C Cold water or hot water Capacity Place settings Refer to the rating plate for other values.
Need help?
Do you have a question about the FSK76727P and is the answer not in the manual?
Questions and answers