Download Print this page
AEG FSK76748P User Manual
Hide thumbs Also See for FSK76748P:

Advertisement

Quick Links

aeg.com/register
EN User Manual | Dishwasher
FSK76748P
aeg.com\register

Advertisement

loading
Need help?

Need help?

Do you have a question about the FSK76748P and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AEG FSK76748P

  • Page 1 EN User Manual | Dishwasher FSK76748P aeg.com\register...
  • Page 2 Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. INSTALLATION....................6 4. PRODUCT DESCRIPTION................7 5.
  • Page 3 • Children between 3 and 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. • Children of less than 3 years of age should be kept away from the appliance unless continuously supervised.
  • Page 4 • Do not use high pressure water sprays and/or steam to clean the appliance. • If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets.
  • Page 5 • Please note that self-repair or non- professional repair can have safety consequences and might void the guarantee. • The following spare parts are available for at least 7 years after the model has been discontinued: motor, circulation and drain pump, heaters and heating elements, including heat pumps, piping and related equipment including hoses, valves, filters...
  • Page 6 Valid only for Germany: Before installation, refer to the chapter "Rückschlagventil" in the German user manual. 3.1 Building in www.youtube.com/electrolux www.youtube.com/aeg How to install your AEG/Electrolux 60 cm Sliding Door Dishwasher min. 560 1240 3.2 Safety caps 5 mm If the furniture panel is not installed, open the appliance door carefully to avoid the risk of injury.
  • Page 7 4. PRODUCT DESCRIPTION Ceiling spray arm Scan the QR code with the camera on your mobile device to be redirected to the app in Upper spray arm the app store. Follow the instructions on your Lower spray arm mobile device to download the app. Filters Scan the QR code with the scanner in the Rating plate...
  • Page 8 5. CONTROL PANEL On/Off button / Reset button A. ECOMETER B. Indicators Delay start button / Remote start button C. Time indicator Display 5.2 ECOMETER MY TIME program selection bar Option buttons (EXTRAS) AUTO Sense program button 5.1 Display The ECOMETER indicates how the programme selection impacts energy and water consumption.
  • Page 9 6. PROGRAMME SELECTION 6.1 MY TIME the temperature and quantity of water as well as the wash duration. MY TIME selection bar allows to select a suitable dishwashing cycle based on 6.3 EXTRAS programme duration. You can adjust the programme selection to your needs by activating EXTRAS.
  • Page 10 6.5 Programmes overview Programme Dishwasher Degree of Programme phases EXTRAS load soil Quick Crockery, cutlery Fresh • Dishwashing 50 °C • ExtraPower • Intermediate rinse • GlassCare • Final rinse 45 °C • ExtraHygiene • AirDry Not applicable • Prewash Pre-rinse Crockery, cutlery Fresh, lightly •...
  • Page 11 Consumption values Water (l) Energy (kWh) Duration (min) Programme 1)2) Quick 11.0 0.620 Pre-rinse 0.010 11.8 0.970 1h 30min 11.9 1.110 2h 40min 11.9 1.210 10.9 0.542 AUTO Sense 12.1 1.220 Machine Care 10.6 0.710 The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of dishes and the degree of soil can change the values.
  • Page 12 You can change the basic settings in setting The lights related to the Previous, OK and mode. Next are on. When the appliance is in setting mode, the How to change a setting bars of the ECOMETER represent available settings. For each setting, a dedicated bar of Make sure the appliance is in setting mode.
  • Page 13 1. Press and hold the on/off button until the negative effect on the washing results and on dishwasher is activated. the appliance. 2. Press and hold Previous and Next for 5 The higher the content of these minerals, the seconds. harder your water is.
  • Page 14 7.5 The rinse aid level Water softener level Amount of water (l) The rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hot rinse phase. It is possible to set the released quantity of rinse aid.
  • Page 15 When AirDry opens the door, the display TimeBeam displays the following information shows the remaining time of the running on the floor below the appliance door: programme. • The programme duration when the programme begins. CAUTION! • 0:00 and CLEAN when the programme is completed.
  • Page 16 4. To activate the wireless connection, press • The display shows Off for a few seconds. and hold simultaneously • The appliance returns to the for 2 seconds. programme selection. • The indicator flashes. • The display shows On for a few 8.3 How to activate the wireless seconds and then AP.
  • Page 17 9.1 The salt container 9.2 How to fill the rinse aid dispenser CAUTION! Use only regeneration salt for dishwashers. Do not use kitchen salt. The salt is used to recharge the resin in the water softener and to assure good washing results in daily use.
  • Page 18 10. DAILY USE 1. Open the water tap. 2. Press and hold until the appliance is The upper ends of the two vertical ribs activated. inside the compartment (B) indicate the 3. Fill the salt container if it is empty. maximum level for filling the dispenser 4.
  • Page 19 10.6 How to delay the start of a • The display shows the programme programme duration. 2. Activate applicable EXTRAS if desired. 1. Select a programme. 3. Close the appliance door to start the programme. 2. Double press The display shows 1h. 10.4 How to activate EXTRAS 3.
  • Page 20 10.10 The Auto Off function Opening the door while the remote start is activated deactivates this function. Activate This function saves energy by switching the the remote start again before you close the appliance off when it is not operating. door;...
  • Page 21 – Make sure that the current level of the 3. Start the Quick programme. Do not add water softener agrees with the detergent and do not put dishes in the hardness of the water supply. baskets. – Follow the instructions in the chapter 4.
  • Page 22 11.6 Unloading the baskets 1. Let the tableware cool down before you After the programme is completed, water remove it from the appliance. Hot items can still remain on the inside surfaces of can be easily damaged. the appliance. 2. First remove items from the lower basket, then from the upper basket.
  • Page 23 12.4 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents. • Do not use abrasive products, abrasive cleaning pads or solvents. 12.5 Cleaning the filters 4. Wash the filters. The filter system is made of 3 parts. 5.
  • Page 24 CAUTION! 3. To install the spray arm back, press it An incorrect position of the filters can downwards. cause bad washing results and damage to the appliance. 12.6 Cleaning the lower spray arm We recommend to clean the lower spray arm regularly to prevent soil from clogging the holes.
  • Page 25 3. Wash the spray arm under running water. Use a thin pointed tool, e.g. a toothpick, to remove particles of soil from the holes. 1. Move the upper basket to the lowest level to reach the spray arm more easily. 2.
  • Page 26 13. TROUBLESHOOTING Refer to the below table for information on WARNING! possible problems. Improper repair of the appliance may With some problems, the display shows an pose a danger to the safety of the user. alarm code. Any repairs must be performed by qualified personnel.
  • Page 27 Problem and alarm code Possible cause and solution Technical malfunction of the appli‐ • Switch the appliance off and on. ance. The display shows iC0 or iC3. The level of water inside the appli‐ • Switch the appliance off and on. ance is too high.
  • Page 28 Problem and alarm code Possible cause and solution The display shows upd. All buttons • The appliance downloads and installs the firmware update automatical‐ are inactive except for the on/off ly when it is available. The display shows upd for the duration of the button.
  • Page 29 Problem Possible cause and solution Poor drying results. • Tableware was left for too long inside the closed appliance. Activate the function AirDry to set the automatic opening of the door and to improve the drying performance. • There is no rinse aid or the dosage of rinse aid is not sufficient. Fill the rinse aid dispenser or set the dosage of rinse aid to a higher lev‐...
  • Page 30 Problem Possible cause and solution Limescale deposits on the tableware, • The level of salt is low, check the refill indicator. on the tub and on the inside of the • The cap of the salt container is loose. door. •...
  • Page 31 Problem Possible cause and solution The app cannot connect to the dish‐ • There is a trouble with the wireless network signal. Check your wire‐ washer. less network and router. Restart the router. • Check if your mobile device is connected to the network. •...
  • Page 32 15. ENVIRONMENTAL CONCERNS appliances marked with the symbol with Recycle materials with the symbol . Put the the household waste. Return the product to packaging in relevant containers to recycle it. your local recycling facility or contact your Help protect the environment and human municipal office.
  • Page 36 The software in this product contains components that are based on free and open source software. AEG gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://aeg.opensoftwarerepository.com (folder NIUS)