Content 1 Introduction ........................4 2 Delivery scope......................... 5 3 Technical data ........................ 6 4 General explanation of symbols ..................7 5 Safety ..........................8 Intended use ..........................8 User groups ..........................8 Use environment ......................... 8 Residual risks ..........................9 6 Cleaning and disinfection ....................
FotoFinder software. The main function of the FotoFinder skeen is to capture images with the camera lens system and to save and display the images for the user.
2 Delivery scope Fig. 1: FotoFinder skeen (front and side view) in charging station FotoFinder skeen skeen charging station Shutter release Side button LED light Magnetic attachment lens with removable attachment cap Power cable Instructions (not shown) CAUTION LED light may lead to short-term impairment of your eyesight.
Model: FotoFinder skeen Manufacturer: FotoFinder Systems GmbH Address: Industriestraße 12, 84364 Bad Birnbach, Germany Dimensions (skeen in charging station): 11 cm x 13 cm x 19.5 cm Weight: skeen (without attachment lens) 422 g Attachment lens 40 g Charging station with power plug...
Adhere to the user manual UK Conformity Assessed Party responsible for UK: FotoFinder Systems Ltd., 100 Addison Road, W148DD London, United Kingdom Do not dispose of electrical and electronic devices with domestic waste The following explains the information on the device's type plate.
5.3 Use environment The FotoFinder skeen is a portable device for mobile use. It can be also be used in the professional healthcare sector, e.g., in clinics or practices, if it is used in combination with other FotoFinder software or systems.
5.4 Residual risks WARNING Despite compliance with all regulations and the implementation of risk-minimizing measures, not all risks can be completely excluded. Residual risks that exist in connection with the use of the product are listed below. Improper operation or failure to adhere to the specified safety information and warnings can cause damage to the user or third parties.
Cleaning and disinfection 6 Cleaning and disinfection NOTE Clean and disinfect the attachment cap after each use. ATTENTION Sanitize with wipes only. Sanitize any components with sanitizing wipes only. ATTENTION Please do not spray directly onto the camera lenses, only on to a cleaning wipe. Any direct contact with liquids can damage the lense or the camera.
Blue pulsing light to status 1 or status 2 after two to three seconds If the LED does not light up, the skeen is not inserted in the charging station correctly or the charging station is not being supplied with power.
7.3 Creating images Switch on the FotoFinder skeen with the side button. Place the device with the lens on the skin and hold it steady. Press the shutter release. Refer to the installed app for the exact sequence.
+49 8563 97720-45 or send an e-mail to: support@fotofinder.de. 8.3 Attachment not detected Detach the attachment lens from the skeen and attach it again Check that it is attached correctly Adhere to the instructions in this user manual (cf. chapter 7.2 Mounting the lens).
Need help?
Do you have a question about the Skeen and is the answer not in the manual?
Questions and answers