Products must be used, installed and operated in accordance with this manual. You may not be able to claim on the AEG manufacturer’s warranty in the event that your product fault is due to failure to adhere to this manual.
Page 4
1.1 Children and vulnerable people safety This appliance can be used by children aged from 8 • years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
ENGLISH The appliance maximum load is 10.0 kg. Do not • exceed the maximum load of each program (refer to the “Programs” chapter). The operating water pressure at the water entry point • from the outlet connection must be between 0.5 bar (0.05 MPa) and 10 bar (1.0 MPa).
Page 6
• Adjust the feet to have the necessary the water flow until it is clean and space between the appliance and the clear. flooring. • Ensure that there are no visible water • Do not install the appliance where the...
ENGLISH 2.6 Service 2.7 Disposal • To repair the appliance contact the WARNING! Authorised Service Centre. Use Risk of injury or suffocation. original spare parts only. • Please note that self-repair or non- • Disconnect the appliance from the professional repair can have safety mains electrical and water supplies.
ENGLISH Level of protection against ingress of solid particles and IPX4 moisture ensured by the protective cover, except where the low voltage equipment has no protection against mois‐ ture Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 10 bar (1.0 MPa) Cold water Water supply Maximum Load...
Page 10
4. Open the door and remove the polystyrene piece from the door seal and all the items from the drum. CAUTION! 5. Carefully put the appliance down on Do not use alcohol, solvents its rear side. or chemical products.
Page 11
ENGLISH Attach the sound barriers at a room temperature. 13. Pull up the appliance in vertical position. We recommend that you keep the packaging and the transit bolts for any movement of the appliance. 5.2 Positioning and levelling 14. Remove the power supply cable and the drain hose from the hose holders.
Page 12
If you install the appliance on a plinth that is not an accessory supplied by Do not use an extension AEG, secure the appliance with the fixing hose if the inlet hose is too plates. This spare part is available in web short.
Page 13
ENGLISH You can extend the drain hose to maximum 400 cm. Contact the authorized service centre to buy the other drain hose and the extension. It is possible to connect the drain hose in different ways: min.600 mm max.1000 mm •...
The rating plate and the 'Technical Data' The power supply cable must be easily chapter indicate the necessary electrical accessible after installing the appliance. ratings. Make sure that they are For any electrical work required to install compatible with the mains power supply.
Page 15
ENGLISH Extra Rinse touch button AutoDose Liquid Detergent Time Save touch button Fabric Softener touch buttons Stains/Prewash touch button and Wi-fi connection and Remote Start permanent Child Lock option touch button Spin touch button Finish In touch button Temperature touch button Start/Pause touch button Plus Steam touch button 6.2 Display...
Page 16
The digital indicator can show: • Program duration (e. g. The time shown when the program is set could not correspond to effective duration and change after ProSense phase. • Maximum load. • Finish in time (e. g. •...
ENGLISH The spin area: Spin speed indicator No Spin indicator. Spin phase is off. Extra Silent indicator. Rinse hold indicator. Pre-wash indicator. Stain indicator. Indicators for options downloadable via App only Linked mode indicator. It lights when both AutoDose tanks are linked and filled with the same detergent.
Page 18
7.4 Introduction appears on the display: to reset the Network Credentials. The options/functions are 7.7 Finish In not selectable with all washing programs. Check Set this option as last after the compatibility between program and other options options/functions and...
Page 19
ENGLISH display and program time is adjusted the washing program. Touch this accordingly. button once to decrease the duration. • In case of smaller load, touch this The indicator blinks in the display button twice to set an extra quick during steam phase.
Page 20
When selecting a pre- drum. This helps to reduce creasing. wash phase and As the program is very quiet, it is AutoDose is active, the suitable for use at night time when...
ENGLISH 8. SETTINGS 8.1 Introduction 8.4 Operating Hours Counter It is possible to visualise the total When pressing a key operating time of the appliance in hours, combination, do not tilt your starting from the first switching on. This fingers downwards . The value will count operating time of the sensors of the underneath cycles (does not include pauses, delayed...
9. BEFORE FIRST USE 3. Make sure to fill the AutoDose tanks During installation or before with liquid detergent and fabric first use you may observe some water in the appliance. softener . Refer to "AutoDose This is a residual water left basic setting "...
Page 23
ENGLISH 10.2 Detergent dispenser with When using liquid AutoDose tanks and manual detergent, make sure that the special container for compartments liquid detergent is inserted. Refer to the When using detergent and "Manual filling the any other treatments, always detergent and additives" follow the instructions that paragraph in this chapter.
Page 24
'AutoDose configuration mode' how to the quantity to use. The suggested change the basic setting, but before: quantity is the combination of three different factors: 1. Identify the water hardness level. • Water hardness level (see the Check the water hardness level in following table);...
Page 25
ENGLISH 5. To set basic dosage touch related tank buttons until default dosage laundry product and two arrows on bottom of display appear. Touch the 2. Lift up the AutoDose cover lid. Temperature button repeatedly to decrease the dosage and the Spin button to increase it: minimum step is 1 ml (each single step) or 10 ml (when button is hold pressed).
Page 26
If tank is not refilled, once a program has started, the indicator will stop blinking and stay steadily lit. Once the program is finished, it will start blinking again. Unless AutoDose is turned OFF, if a compartment has reached low level, the...
Page 27
ENGLISH Please read "Detergents type and quantity of detergent" in "Hints and tips" chapter. 1. Open the detergent dispenser. 10.8 Deactivating the AutoDose If you prefer to use the compartments for manual filling as default choice, you can deactivated the AutoDose tanks completely.
Page 28
3. Gently close the detergent dispenser, till click engagement. If the machine has not been used for more than 4 weeks with filled tanks, detergent/ softener can become viscous or dry out. It is needed to clean the drawer as indicated in 'Care and Cleaning' chapter.
11.1 AEG App app and additional hidden programs AEG App app provides you with a wide choice of additional hidden programs. Connect the appliance to AEG App and you will be able to choose the program that suits your needs most.
Page 30
Program Program description Machine washable wool, hand washable wool and other fabrics with «hand washing» care symbol Wool Cotton and synthetic items lightly soiled or worn only once. 20min 3kg Cotton, synthetic and mixed items. Special steam cycle without...
Page 31
ENGLISH Program temperature, maximum spin speed and maximum load Program Default tempera‐ Reference spin Maximum load ture speed Temperature Spin speed range range 30 °C 1600 rpm 5.0 kg 60 °C - 30 °C 1600 rpm - 400 rpm PowerClean 59min 40 °C 1600 rpm 10.0 kg...
Page 32
DO NOT set this mode with the following Do not use any detergent! type of items: The Steam programs do not • Items that are not suitable for tumble remove particularly intense drying. odour and do not perform • Items with label "Dry clean only".
15/Android By this functionality you can receive 7.1 and above. Install the notifications, control and monitor your AEG App, create an account appliance from your mobile devices. and accept the Terms and Conditions and AEG Privacy The Wi-Fi functionality is off as factory Policy to use the connected default setting.
Page 35
The access point will be open for about 3 connection in the appliance. If not, minutes. read the next paragraph 'Configuring 5. Configure the AEG App app on your the appliance wireless connection'. smart device and follow the 4. Start the application. Select the...
Page 36
1. Touch the Remote Start button and the indicator blinks on the display for a few seconds. Every time you switch the appliance on, the appliance takes about 10 seconds to connect to the network 2. Touch the Start/Pause button to automatically.
ENGLISH 12.6 Wi-Fi Always On It is possible to turn the appliance on by pressing the On/Off button or through The Wi-Fi Always On function is the App. available in the App. The Wi-Fi Always On This function keeps the appliance function may affect your connected to the network even when the energy consumption.
Page 38
13.4 Setting a program The program starts, the door is locked. The display shows the indicator If you wish to change the The drain pump can operate automatic detergent or fabric shortly before the appliance softener dosage, enter the fills water.
Page 39
ENGLISH 13.8 Program phase decrease, adjusted accordingly the load detected, the number of bars indicators indicates the load in quarter (from 1 to 4, 4 bars in case of overload), the When the program starts the indicator of maximum declared load indicator the running phase flashes and the other comes on again.
Page 40
In the display all washing phase If the ProSense phase is indicators become steady and the time already carried out and the water filling is already area shows . started, the new program The indicator of the Start/Pause starts without repeating the button goes off.
ENGLISH • If you have set , the appliance Press the On/Off button to activate drains the water and spins. the appliance again. • After 5 minutes from the end of the • If you have set , the appliance washing program only drains the water.
Page 42
First, follow these generic rules: – powder detergents (also tablets and single-dose detergents) for all types of fabric, excluding delicate. Prefer powder detergents containing bleach for whites and laundry sanitization, – liquid detergents (also single-dose detergents) , preferably for low •...
ENGLISH • Loading the appliance to the in a tumble dryer. This will save maximum capacity indicated for energy during drying! each programs helps to reduce 14.5 Water hardness energy and water consumption. • With adequate pre-treatment, stains If the water hardness in your area is high and limited soiling can be removed;...
Page 44
Regularly CAUTION! examine the seal. Coins, buttons, other Do not use alcohol, solvents small items can be recovered at the end or chemical products. of the cycle. CAUTION! Do not clean the metal surfaces with chlorine-based detergent.
Page 45
ENGLISH 4. Run a cotton program with the highest temperature without detergent. If your appliance can be connected to Wi-Fi, the special program Machine Clean is also downloadable through the APP. 15.8 Cleaning the detergent dispenser and the AutoDose tanks CAUTION! Do not change brand or type of detergent, fabric...
Page 46
Close it till liquid. "click" sound. 5. Wash the drawer and all inserts under running water or clean it with a damp cloth. CAUTION! Press the bottom cover as indicated in the picture.
Page 47
ENGLISH b. Place the bottom cover and press till "click" sound. c. Place the top cover on the tanks compartment and press till "click" sound. d. Replace components on manual compartment. 11. Insert the detergent dispenser into the guide rails and gently close it till "click"...
Page 48
WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down Proceed as follows to clean the pump: 1. Open the pump cover.
Page 49
ENGLISH occasionally to remove any deposit, collected over the time: 1. Remove the inlet hose from the tap and clean the filter. 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages.
15.12 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
Page 51
ENGLISH With some problems, the display shows an alarm code and the Start/Pause button may flash continuously: If the appliance is overloaded, remove some items from the drum and/or keep pressed the door while touching the Start/Pause button until the indicator stops flashing (see the picture below).
Page 52
• The program was not finished properly or the appliance stop‐ ped too early. Switch the appliance off and on again. Internal fail. No com‐ • If the alarm code appears again, contact the Authorised Serv‐ munication between ice Centre.
Page 53
ENGLISH Problem Possible solution • Make sure that the couplings of the water hoses are tight and there is not water leakages. • Make sure that the water inlet hose and the drain hose have no damages. There is water on the •...
Page 54
Problem Possible solution The display shows • The appliance is downloading any available updates. Wait un‐ til the update process is complete. If you deactivate the appli‐ . All buttons are ance during update, it resumes when you activate the appli‐...
ENGLISH 16.2 Emergency door To open the door, proceed as follows: opening 1. Press the On/Off button to switch the appliance off. In case of power failure or functioning 2. Disconnect the mains plug from the failure the appliance door remains mains socket.
Page 56
• Set the desired options by means of When using a liquid the corresponding touch buttons (3). detergent in manual • Put the laundry in the drum, one item compartment, insert the a time without exceeding the container for liquid maximum suggested load.
3) Tested for Staphylococcus aureus, Enterococcus faecium, Candida albicans, Pseudomonas aerugino‐ sa and MS2 Bacteriophage in external test performed by Swissatest Testmaterialien AG in 2021 (Test Report No. 202120117). 18. WARRANTY - AUSTRALIA AND NEW ZEALAND FOR SALES IN AUSTRALIA AND NEW ALL AEG BRANDED APPLIANCES ZEALAND...
Page 58
This document sets out the terms and a period of 60 months, following the conditions of the product warranties date of original purchase of the for AEG Appliances. It is an important Appliance. document. Please keep it with your 4. Repair or replace warranty: During...
Page 59
Appliance meet its obligations under this available; warranty. c. have the proof of purchase (e.g. an invoice) available; Important Notice Before calling for service, please ensure that the steps listed in clause 8 above have been followed. SERVICE AUSTRALIA aeg.com/au...
FOR SERVICE FOR SPARE PARTS or to find the address of your nearest au‐ or to find the address of your nearest spare thorised service centre in Australia parts centre in Australia PLEASE CALL 1300 363 664 PLEASE CALL 13 13 50...
Page 64
AEG app The software in this product contains components that are based on free and open source software. AEG gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://aeg.opensoftwarerepository.com (folder NIUS)
Need help?
Do you have a question about the LF9516O8Q and is the answer not in the manual?
Questions and answers