Table of Contents
Advertisement
Quick Links
Olarm for Texecom Elite
Table of contents
Note:
https://help.olarm.com/portal/en/kb/articles/olarm-for-texecom-elite
Help Centre
Advertisement
Table of Contents
Related Manuals for Olarm PRO
Summary of Contents for Olarm PRO
-
Page 1: Table Of Contents
Table of contents Step 1 - Locate your alarm panel Step 2 - Unbox your Olarm PRO Step 3 - Download the Olarm mobile app & register your device Step 5 - Power down the alarm panel Step 6 - Connect the Olarm PRO Step 7 - Power up the alarm panel Step 8 - Check your Olarm PRO’s status... -
Page 2: Step 1 - Locate Your Alarm Panel
Note: Olarm App Part Arming guide for Texecom Elite Troubleshooting Texecom Connection Problems Final Checklist Installation Position Olarm PRO Connectivity Testing App/Keypad Functionality Control Room Signal Check Step 1 - Locate your alarm panel Note that the alarm panel is not the keypad. Alarm panels are typically installed in a hidden location in the home such as a cupboard or basement. -
Page 3: Step 3 - Download The Olarm Mobile App & Register Your Device
Step 3 - Download the Olarm mobile app & register your device Scan the QR code (left), or navigate to your App store on your device and search for ‘Olarm’. This Olarm PRO will require an active subscription to function. Please contact your installer or speak to ... -
Page 4: Step 5 - Power Down The Alarm Panel
Plug the 5-pin side of the connector cable into the port marked ‘COM1’ on the alarm panel and connect the 4-pin side of the connector cable to the port marked ‘UNIVERSAL’ on the Olarm PRO. Note: If Com1 is in use, plug into Com2 (See Step 4.) Step 7 - Power up the alarm panel Power up the alarm panel by reconnecting the battery and plugging the transformer back into the power source. -
Page 5: Troubleshooting Led States
If your device LED is red - please check the connection between the Olarm PRO and the alarm panel. If your device LED is orange - please ensure that the Olarm PRO is located in an area with good mobile signal strength and away from any metal enclosures that could be interfering with the signal. -
Page 6: Step 9 - Mount The Olarm Pro
Do NOT install the Olarm PRO inside the alarm panel box. The Olarm PRO device is NOT weather resistant, and you will need to install it in a suitable non-metal enclosure if outdoors. - Page 7 Make sure the Olarm is plugged into the programmed ComPort on the panel. Final Checklist Olarm recommends that the following checklist be used to ensure that all aspects of the installation have been covered. Installation Position Have I mounted the Olarm PRO securely away from the alarm panel to ensure minimal signal interference?
- Page 8 Control Room Signal Check Have I checked with the control room that the monitoring software recorded the signals? Control Room: Disarm Panic Alarm Signal +27 21 009 0911 | support@olarm.com | https://www.olarm.com E & OE. Terms & conditions may apply. https://help.olarm.com/portal/en/kb/articles/olarm-for-texecom-elite...
Need help?
Do you have a question about the PRO and is the answer not in the manual?
Questions and answers