Sony HCD-MD333 - Hi Fi Cd/minidisc Component Service Manual page 21

5-7. DISPLAYS DURING TEST MODE
The display changes according to the following sequence each time the 1/u button is pressed.
1. Mode display
"TEMP ADJUST" and "CPLAYMODE" are displayed.
2. Error rate display
The error rate is displayed as follows.
C = AD =
C = :Indicates the C1 error.
AD = :Indicates ADER.
3. Address display
The address is displayed as follows. (MO: Recordable disc, CD: Disc for palyback only)
When the CD-MD SYNC button is pressed, the display will switch between groove
and pit.
h = s = (MO pit and CD)
h = a = (MO groove)
h = Indicates the header address.
s = Indicates the SUBQ address.
a = Indicates the ADIP address.
Note: Displayed as "–" when servo is operated.
4. Auto gain display (Not used in servicing)
The auto gain is displayed as follows.
AG = / .
5. Detrack check display (Not used in servicing)
The detrack is displayed as follows.
ADR =
6. IVR display (Not used in servicing)
IVR is displayed as follows.
[ ][ ][
Meanings of other displays
Display
Recording mode ON
REC
ABCD adjustment completed
ATT
Tracking offset cancel ON
OVER
Focus auto gain OK
SHUFFLE
Pit
TRACK
High reflection rate
DISC
CLV-S
LEVEL-SYNC
CLV LOCK
SYNC
Contents
When Lit
– 21 –
Detrack check display (Not used in servicing)
When Off
Recording mode OFF
Tracking offset cancel OFF
Groove
Low reflection
CLV-A
CLV UNLOCK
Mode display
Error rate display
Address display
Auto gain display (Not used in servicing)
IVR display (Not used in servicing)