Table of Contents
Advertisement
3. Ending the continuous playback mode
1 Press the ^ (CD) button. The display changes to "CPLAY MODE".
2 Press the 6 (MD) button to remove the disc.
Note : The playback start addresses for IN, MID, and OUT are as follows. To display the playback position address on the display, press
the 1/u button to display "CPLAY (
IN:
40h cluster
MID: 300h cluster
OUT: 700h cluster
5-5-2. Operating the Continuous Recording Mode
1. Entering the continuous recording mode
1 Set a recordable disc in the unit. (Refer to Note 3.)
2 Rotate the VOLUME knob and display "CREC MODE".
3 Press the p (CD) button to change the display to "CREC MID".
4 When access completes, the display changes to "CREC (
Note : The numbers " " displayed indicate the recording position address.
2. Changing the part to be recorded
1 When the p (CD) button is pressed during continuous recording, the display changes as below and the recorded part can be changed.
REC
The
display is off while changing.
"CPLAY MID" n "CPLAY OUT" n "CPLAY IN"
2 When access completes, the display changes to "CREC MODE" and the
Note : The numbers " " displayed indicate the recording position address.
3. Ending the continuous recording mode
1 Press the ^ (CD) button. The display changes to "CREC (
2 Press the 6 (MD) button to remove the disc.
Note 1 : The recording start addresses for IN, MID, and OUT are as follows.
IN:
40h cluster
MID: 300h cluster
OUT: 700h cluster
Note 2 : The ^ (CD) button can be used to stop recording anytime.
Note 3 : Do not perform continuous recording for long periods of time above 5 minutes.
Note 4 : During continuous recording, be careful not to apply vibration.
5-5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If set accidentally, press the ^ (CD) button immediately to exit it.
5-6. FUNCTIONS OF OTHER BUTTONS
Function
·P
Sets continuous playback when pressed in the STOP state. Turns ON/OFF the tracking servo when pressed during continuous
playback.
p
Stops the continuous playback and recording.
) +
Moves the sled to the external circumference only while the button is pressed.
= 0
Moves the sled to the internal circumference only while the button is pressed.
Switches between pit and groove when pressed.
CD-MD SYNC
1/u
Switches the displayed contents when pressed.
6 (MD)
Ejects the disc.
Exits the test mode.
REPEAT
)".
REC
)" and the
REC
)", and the
Contents
– 20 –
display lights up.
display lights up.
REC
display lights up.
Advertisement
Table of Contents
