Subscribe to Our Youtube Channel
Related Manuals for SCIEX Gas Generator N38
Summary of Contents for SCIEX Gas Generator N38
- Page 1 SCIEX Gas Generator N38 Operator Guide SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B December 2022...
-
Page 2: Table Of Contents
Generator Overview General Dimensions Unit Connections Unit Controls Air Connection Commissioning Connecting to the application Tubing Lengths Service Requirements Service Schedule Cleaning Troubleshooting Contact us SCIEX Support Page 2 Page 2 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 3: Change History
Users can refer to the contents page to find the relevant information. Review each of the following sections carefully. Thank you for selecting SCIEX to meet your gas generation needs, and should you require any further assistance or support do not hesitate to contact SCIEX. -
Page 4: Safety Notices
If the user employs an operating procedure, item of equipment or a method of working which is not specifically recommended by SCIEX, the user must ensure that the equipment will not be damaged or become hazardous to persons or property. -
Page 5: Technical Specification
Drain Outlet 1 × ¼” BSPP Pressure Gauges NOTE – These performance characteristics are valid only when paired with an approved SCIEX application. Refer to current application matrix for a list of supported products. General Dimensions cm (inches) W × D × H 42.8 ×... -
Page 6: Unpacking
Unpacking Although SCIEX takes every precaution with safe transit and packaging, it is advisable to fully inspect the unit for any sign of transit damage. Check ‘SHOCKWATCH’ and ‘TIP-N-TELL’ labels for signs of rough handling prior to unpacking. Any damage should be reported immediately to the carrier and SCIEX. -
Page 7: Fittings Kit Contents
6. No. 8 Wall Plug × 7. No. 8 Screw × All of the generators output ports are located on the output panel at the side of the unit. Page 7 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 8: Installation
Refer to the drawing on the following page for the general dimensions of the unit. Minimum Operating Ambient Temperature: 5 °C (41 °F) Maximum Operating Ambient Temperature: 30 °C (86 °F) Page 8 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 9: Generator Overview
428 mm / 16.8” 250 mm / 9.8” The generator must always be placed on a flat, level surface. Failure to do so will affect the performance of the generator. WARNING Page 9 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 10: Unit Connections
Unit Connections ¼" Compression Fitting (Curtain) ¼" Compression Fitting (Source) ¼" Compression Fitting (Exhaust) Unit Controls Pressure Gauges Page 10 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 11: Air Connection
Air Connection SCIEX Gas Generator N38 should be connected to a clean, dry, OIL - FREE source of compressed air. A minimum inlet pressure of 120 psig (8.3 barg) is required. Any doubts as to the suitability of your compressed air supply should be referred to SCIEX or any of their authorised partners. -
Page 12: Commissioning
In circumstances of no demand, the Generator remains operational and will provide Nitrogen immediately as demand resumes. Page 12 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 13: Connecting To The Application
” O/D, ⁄ ” I/D). Tubing and fittings not supplied in the fittings kit. > 40 metres: Contact SCIEX with the relevant distance and we will calculate the flow resistance and the tubing size required. A combination of ”/ ⁄... -
Page 14: Service Requirements
* Quote your generator serial number when ordering your Maintenance Kit to ensure selection of the appropriate kit for your generator. Note: To be serviced by manufacturer. Page 14 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 15: Cleaning
Under no circumstances should any solvents or abrasive cleaning solutions be used as these can contain fumes that could be harmful to the generator. CAUTION Care should be taken with Leak Detections Liquids. CAUTION Page 15 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 16: Troubleshooting
Troubleshooting Problem Possible Solution • Check pressure gauges are showing normal pressure. The mass spec is reporting low pressure. • Contact your Technical Assistance Centre. Page 16 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B... -
Page 17: Contact Us
SCIEX and its representatives maintain a staff of fully-trained service and technical specialists located throughout the world. They can answer questions about the system or any technical issues that might arise. For more information, visit the SCIEX website at sciex.com or contact us in one of the following ways: •... - Page 18 Page 18 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B...
- Page 19 Page 19 / 20 SCIEX Gas Generator N38 Operator Guide RUO-IDV-05-14029-B...
- Page 20 Any such use is intended only to designate those manufacturers’ products as supplied by SCIEX for incorporation into its equipment and does not imply any right and/or license to use or permit others to use such manufacturers’ and/or their product names as trademarks.
Need help?
Do you have a question about the Gas Generator N38 and is the answer not in the manual?
Questions and answers