Advertisement
Available languages
Available languages
I
Installation
Instructions
Air Conditioner
I-_
Questions?
Call 800.GE.CARES (800.432.2737)
or visit our Website
at: GEAppliances.com
In Canada, call 1.800.561.3344
or visit www.GEAppliances.ca
I
BEFORE YOU BEGIN
Read these instructions
completely
and carefully.
• IMPORTANT - Save these
instructions
for local
inspector's
use.
• IMPORTANT
-
Observe
all
governing
codes
and ordinances.
•
Note to Installer-
Be sure to leave these
instructions
with the Consumer.
•
Note to Consumer
- Keep these instructions
for
future reference.
• Skill level - Installation
of this appliance
requires
basic mechanical
skills.
• Completion
time - Approximately
1 hour
• We recommend
that two people install
this product.
•
Proper installation
is the responsibility
of the
installer.
•
Product failure due to improper
installation
is not
covered under the Warranty.
• You MUST use all supplied parts and use proper
installation
procedures
us described in these
instructions
when installing this air conditioner.
(_
ELECTRICAL REQUIREMENTS
Some models require a llS/120-volt
AC,
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the possibility
of electric shock hazard. If the wall outlet you plan to
use is only a 2-prong outlet, it is your responsibility to
have it replaced with a properly grounded 3-prong wall
outlet.
©
@
Some models require 230/208-volt
AC,
protected with a time-delay fuse or circuit
breaker. These models should be installed on
their own single branch circuit for best
performance and to prevent overloading
house or apartment
wiring circuits, which
could cause a possible fire hazard from
overheating wires.
ACAUTION:
Do not, under any circumstances,
cut or remove
the third
(ground) prong from the power cord.
Do not change the plug on the power cord
of this air conditioner.
Aluminum
house wiring
may present
special
problems--consult
a qualified
electrician.
TOOLS YOU WILL NEED
Phillips-head
screwdriver
Flat-blade
screwdriver
Pencil
Ruler or tape measure
Level
Scissors or knife
Power cord includes a current interrupter device. A
test and reset button is provided on the plug case. The
device should be tested on a periodic basis by first
pressing the TEST button and then the RESETbutton
while plugged into the outlet. If the TEST button does
not trip or if the RESETbutton will not stay engaged,
discontinue use of the air conditioner and contact a
qualified service technician.
Advertisement
