GE AEM12AP Owner's Manual And Installation Instructions page 5

GEAppliances.com
Cool Mode
Use the Cool mode at Low, Meal,High or Auto Fen
Speed for cooling. Use the Temperature Increase •
/ Decrease • pads to set the desired temperature
between 64°Fand 86°Fin l°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on
and off to keepthe room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Setthe thermostat at a higher
number and the indoor air will become warmer.
NOTE:If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan
setting to a Cool setting, it may take approximately
3 minutes for the compressor to start and cooling to
begin.
Cooling Descriptions
For Normal Cooling-Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling-Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling-Select the
Cool mode and Low fan with a middle set
temperature.
Energy Saver Mode
Controls the fan.
ON--The fan will cycle on and off with the
compressor. This results in wider variations of room
temperature and humidity. Normally used when the
room is unoccupied. NOTE:Thefan may continue to
run for a short time after the compressor cyclesoff.
OFF--Thefun runs oil the time, while the compressor
cycles on and off.
Fan Only Mode
Use the FanOnly Mode at Low, Med or High fan
speed to provide air circulation and filtering without
cooling. Since fan-only settings do not provide
cooling, a Settemperature cannot be entered. The
room temperature will appear
in the display.
NOTE:Auto Fan Speed cannot be used when in the
Fan Only Mode.
Auto Fan Speed
Set to Auto fun speed for the fun speed to
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
If the room needs more cooling, the fun speed
will automatically increase. If the room needs less
cooling, the fun speed will automatically decrease.
NOTE:Auto Fan Speed cannot be used when in the
Fan Only Mode.
Remote Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
Hoke sure nothing is between the air conditioner
and the remote control that could block the
signal.
The remote control signal has o range of
up to 20 feet.
Make sure batteries ore fresh and installed
correctly as indicated on the remote control.
Remote contains o magnet allowing it to attach
to metal surfaces.
Power Outage Recovery Feature
In the case of o power outage or interruption, the
unit will automatically re-start in the settings lost
used offer the power is restored. If the Delay 1-24hr
feature was set, it will resume countdown. You may
need to set o new time if desired.