Shark POWERDETECT RV2800S Owner's Manual page 10

MAINTENANCE
CLEANING THE ROBOT'S FILTER
For optimal suction power, after each use, clean the filter inside the robot's dust bin.
Remove and empty the dust bin. Clean any hair or
debris off the Anti-Tangle Comb on the back of
the dust bin.
Lightly tap the filter to remove debris every time
you empty the dust bin.
NOTE: Make sure to insert the dust bin completely, until it clicks into place.
Pull filter out of the dust bin by the tabs.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot until it clicks into
place.
s h a r kc l e a n . c o m
MAINTENANCE
CLEANING THE SENSORS AND CHARGING CONTACTS
THE SENSORS ON THE ROBOT REQUIRE OCCASIONAL MAINTENANCE. With a dry cloth or cotton swab,
gently dust off the sensors located on the bottom and sides of the robot.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.
s h a r kc l e a n . c o m