Troubleshooting - IcyBreeze V2 PRO Owner's Manual

Troubleshooting

I hear a loud whining noise
If you hear a loud whine, this is an indication that the pump is running dry. Make sure the unit has
been filled with water to the minimum fill line with 2 q
Water is leaking around the drain
Periodically, the nut on the outside of the drain may need to be retightened as temperature
changes can cause the seal to loosen over time. Tightening the nut by the drain plug until the
black rubber seal on the inside starts to flex and the dr in cannot spin will provide a water tight
seal.
Battery will not charge
If the battery only has a partial connection to the charger, the charger can give you a bad reading
for its status. If the battery does not have a good connection to the charger, it will not charge
no matter how long it stays on. Check the charge indicator button on the battery pack itself to
confirm you have lights coming on. Disconnect and r connect the battery. The battery should
physically click into place. This may take more force than expected the first few times a new
battery is connected to a charger.
If the charger has a blinking yellow light, that can mean that the battery has a low voltage or
that the battery is too hot. If you do not get any lights coming on when you press the battery
indicator button, the blinking yellow light should change to a blinking red light after approximately
15 minutes. If you have lights coming on the battery indicator and get the blinking yellow light,
disconnect the battery and let it cool off for 15 minutes before trying again. If the problem
persists, contact IcyBreeze.
There is no air blowing
The fan gets its power from the battery pack or continuous power. If you are going to run the
unit on battery power, be sure the battery pack is fully charged. The solid-state control panel
does not contain any user-serviceable parts. If you are experiencing difficulties, contac
IcyBreeze.
IcyBreeze not cooling effectively
• Check that there is sufficient ice and appropriate wate level up to the "Minimum Water Fill"
line inside cooler.
• Make sure the lid is closed. Do not run unit with the lid opened.
• Check to see if the fan is working properly at all three speeds.
• Check to see if the water is flowing from the return li e.
• Check that there are no obstructions at the bottom of the pump cover.
rts of water.
9