IcyBreeze V2 PRO Owner's Manual page 10

• Turn the unit off and then on, allow 20 seconds for the water to flow through the system an
come out of the discharge hose after turning the unit back on.
• IcyBreeze contains a submersible pump that has been tested before installation. The
• pump does not contain any user-serviceable parts.
• If flow or cooling does not resum , then please contact IcyBreeze.
• Water can accumulate in the radiator during extended use. If loss of air pressure occurs, turn o
the fan, open and close the lid, then turn the unit back on.
Misting System on
Platinum+Misting and
Ultimate
Both the Platinum Pro and Ultimate model IcyBreeze are equipped with a misting system in the
flex-tube on top of the coole . To use this function, simply add water to the cooler and press the
"Mist" button on the control panel. After a slight delay a foggy mist will appear, coming from the
flex-tub .
If after 2 minutes the mist is not working there is a blockage in either the mist nozzle or the sand
filter located under the battery dock cove . FIRST unscrew the mist nozzle from the center of the
flex-tub . Ensure water is coming out from this spot, if not then the blockage is in the sand filte .
If water is coming out, the blockage is in the mist nozzle. For easy cleaning the mist nozzle is 2
pieces. Unscrew the two pieces from each-other (It may require extra force to separate these
pieces, feel free to use the tools at your disposal).
After separated, thoroughly clean by running the pieces under a stream of water and blowing
through both ends to ensure no build-up is remaining. Screw all pieces back together and continue
normal usage. If mist is still not flowing after another 2 minutes replace the mist nozzle with a
new one. To change sand filte , remove the six #1 Phillips head screws on the battery dock cover.
Underneath will be the filter held in place by two water lines. Remove the lines and replace with a
new filter available at www.IcyBreeze.com
Return Policy can be found at IcyBreeze.com
10 10