Boardcon Embedded Design CM3576 Reference User Manual page 5

Table of Contents

Advertisement

HDMI 2.1 support FRL mode
Supports 4 lanes MIPI DSI up to 4K@60Hz
Supports PD1.4a interface up to 4K@60fps
Supports RGB 24bit output
Supports E-ink screen interface
-
Video/Image Input
Supports 3-CH MIPI 4lanes CSI interfaces
or 4-CH MIPI 2lanes + 1-CH 4lanes CSI interfaces
Supports DVP 8-bit input
Audio
- Five I2S/PCM interfaces
- Support 8-ch TX/RX on I2S0/1
- Support Mic array Up to 8ch PDM/TDM interface
- Support 2-ch SPDIF output
- Support 2-ch SPDIF input
- Support voice activity detection
USB / PCIE/SATA3
- Two USB2.0 OTG interfaces
- One Type-C or DP interfaces
- One USB3.0 Host or PCIE2.1x1 or SATA3 interface.
- One PCIE2.1x1 or SATA3 interface.
- SATA3 support five device each port via PM switch
Ethernet
- On board
RTL8211F/ YT8531
I2C
- Up to 9-CH I2C
- Support standard mode and fast mode(up to 400kbit/s)
I3C
- Up to 2-CH I3C
- Support HDR mode(up to 30Mbps)
- I2C compatible
SDIO / SDMMC
- Support SDIO 3.0 protocol
- Support SD3.0 card
SPI
- Up to 5-ch SPI controllers,
- Full-duplex synchronous serial interface
UART
- Support up to 12 UARTs
- UART2 with 2 wires for debug
- Embedded two 64byte FIFO
CAN
- Support up to two CAN controller
- Support CAN FD protocol
Customize the embedded system based on
4
Your Idea

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CM3576 and is the answer not in the manual?

Table of Contents