Advertisement
Main Menu:
To change set value & hystersis based on relay mode & grouping
For Example:
* Group No 1 If 1st channel, have a set point as a high alarm,
1 relay
* Group No 2 nd channel, have a set point as a low alarm, 1 relay
For, 3rd, 4th, 5th, 6th, 7th, 8th channel have a set point as
high & low alarm, 2 relay
* Press & Hold
key for auto scrolling or manual scrolling.
* In hold mode use
&
* If LED is blinking than Alarm is on.
* If LED is continuously on Alarm was on.
* If LED is off than Alarm is off.
* If lower display shows nRM than it means all Alarms are off
for that channel.
Menu 1 :-
To configurable scan time, Input selection, for individual channel,
skip or unskip channel, dp selection
Menu 2 :-
To configurable no.of channel per group. (User can define
maximum 4 group & maximum 8 channel/group), relay mode
Menu 3 :-
Set Point Selection
Menu 4 :-
To configurable offset for individual channel, if require.
Menu 5 :-
Coomunication : RS-485 Modbus Facility
key to select next channel.
MENU-1
Input Selection
Press
+
SET
5
Scan time. (Second)
SCN
Presskey.
SET
UNS
/
CH 1
Use
Presskey.
SET
/
UNS
Ch 8
1
(Repeat the same procedure for all 8 channels).
Presskey.
SET
J-TY
To change the Input Type, Press
( J, K , PT-100,PT.1 ).
CH 1
Presskey.
SET
J-TY
(Repeat the same procedure for all 8 channels).
Ch 8
1
Presskey.
SET
Press
key to save & exit.
ENT
Note :- Values can be changed
by pressing
key.
S 1P
or
key to Skip or Unskip Channel.
S 1P
or
keys.
or
Key.
Advertisement
Need help?
Do you have a question about the MS-1248-M1 and is the answer not in the manual?
Questions and answers