Welcome to Electrolux! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.electrolux.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. INSTALLATION....................6 4. PRODUCT DESCRIPTION................7 5.
Page 3
• Children of less than 3 years of age should be kept away from the appliance unless continuously supervised. • Children should be supervised to ensure that they do not play with the appliance. • Keep detergents away from children. •...
• If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused.
Page 5
discontinued: motor, circulation and drain pump, heaters and heating elements, including heat pumps, piping and related equipment including hoses, valves, filters and aquastops, structural and interior parts related to door assemblies, printed circuit boards, electronic displays, pressure switches, thermostats and sensors, software and firmware including reset software.
3.1 Building in www.youtube.com/electrolux www.youtube.com/aeg How to install your AEG/Electrolux 60 cm Sliding Door Dishwasher 3.2 Safety caps If the furniture panel is not installed, open the appliance door carefully to avoid the risk of injury.
4. PRODUCT DESCRIPTION Upper spray arm Cutlery basket Lower spray arm Lower basket Filters Upper basket Rating plate Salt container The graphic is a general overview. For Air vent more details, refer to other chapters or documents provided with the appliance. Rinse aid dispenser Detergent dispenser 4.1 Beam-on-Floor...
5. CONTROL PANEL On/Off button / Reset button Option buttons (EXTRAS) Delay start button AUTO Sense program button Display MY TIME program selection bar 5.1 Display 5.2 ECOMETER The ECOMETER indicates how the programme selection impacts energy and water consumption. The more bars are on, the lower the consumption is.
6. PROGRAMME SELECTION 6.1 MY TIME consumption for crockery and cutlery with normal soil. This is the standard MY TIME selection bar allows to select a programme for test institutes. suitable dishwashing cycle based on programme duration. 6.2 AUTO Sense The AUTO Sense programme automatically adjusts the dishwashing cycle to the type of load.
Page 10
Programme Dishwasher Degree of Programme phases EXTRAS load soil Not applicable • Prewash Pre-rinse Crockery, cutlery Fresh, lightly • Dishwashing 60 °C • ExtraPower dried-on • Intermediate rinse • GlassCare • Final rinse 50 °C • AirDry 1h 30min Crockery, cut‐ Normal, lightly •...
Water (l) Energy (kWh) Duration (min) Programme 1)2) Pre-rinse 0.020 10.6 0.990 1h 30min 10.6 0.990 2h 40min 12.4 1.170 0.835 AUTO Sense 11.6 1.110 Machine Care 0.510 The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of dishes and the degree of soil can change the values.
Page 12
How to change a setting Make sure the appliance is in setting mode. 1. Use Previous or Next to select the bar of the ECOMETER dedicated to the desired setting. • The bar of the ECOMETER dedicated 1 2 3 4 5 to the chosen setting flashes.
when it occurs at any point at the beginning or in the middle of a programme. All the consumption values mentioned in this section are determined in line with the currently applicable standard in laboratory conditions with water hardness 2.5mmol/L (water softener: level 3) according to the regulation: 2019/2022 / UK Ecodesign 2021/745.
Page 15
3. Fill the rinse aid dispenser. 4. Open the water tap. 5. Start the programme Quick to remove any residuals from the manufacturing process. Do not use detergent and do not put dishes in the baskets. After starting the programme, the appliance recharges the resin in the water softener for up to 5 minutes.
You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 or 6 (highest quantity). 9. DAILY USE 1. Open the water tap. 2. Press and hold until the appliance is For information about the detergent activated.
Page 17
9.4 How to activate EXTRAS The light related to the button is on. 3. Close the appliance door to start the 1. Select a programme using MY TIME countdown. selection bar. During the countdown, it is not possible to 2. Press the button dedicated to the option change the delay time and the programme you want to activate.
The function comes into operation The Auto Off function switches the appliance automatically: off automatically. • When the programme is completed. All buttons are inactive except for the on/off • After 5 minutes if a programme was not button. started. 9.11 End of the programme When the programme is complete, the display shows 0:00.
• Make sure that the water softener level is • Use the appliance to wash dishwasher- correct. If the level is too high, the safe items only. increased quantity of salt in the water • Do not wash the following materials in the might result in rust on cutlery.
Page 20
11.1 Machine Care 11.3 Removal of foreign objects Machine Care is a programme designed to Check the filters and the sump after each use clean the appliance interior with optimal of the dishwasher. Foreign objects (e.g. results. It removes limescale and grease pieces of glass, plastic, bones or toothpicks, buildup.
Page 21
7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage...
3. To install the spray arm back, press it downwards. 2. Wash the spray arm under running water. Use a thin pointed tool, e.g. a toothpick, to remove particles of soil from the holes. 11.7 Cleaning the upper spray arm Do not remove the upper spray arm.
Page 23
Problem and alarm code Possible cause and solution The programme does not start. • Make sure that the appliance door is closed. • If the delay start is set, cancel the setting or wait for the end of the countdown. •...
Page 24
Problem and alarm code Possible cause and solution The remaining time in the display in‐ • This is not a defect. The appliance is working correctly. creases and skips nearly to the end of the programme duration. Small leak from the appliance door. •...
Page 25
12.2 The dishwashing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and the basket loading leaf‐ let. • Use more intensive washing programme. • Activate the ExtraPower option to improve the washing results of a selected programme.
Problem Possible cause and solution Limescale deposits on the tableware, • The level of salt is low, check the refill indicator. on the tub and on the inside of the • The cap of the salt container is loose. door. •...
rating plate of the appliance. Refer to the product information sheet. Keep the energy chapter "Product description". label for reference together with the user manual and all other documents provided For more detailed information about the with this appliance. energy label, visit www.theenergylabel.eu. For more detailed information about the 13.2 Link to the product information energy label, visit www.theenergylabel.eu.
Need help?
Do you have a question about the EES47325L and is the answer not in the manual?
Questions and answers