Page 2
Please read this user manual first! Dear Customer, We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use.
• Do not operate the product the Authorised Service if the power cable / plug is Agent. Manufacturer damaged! Call the Gram shall not be held liable for Service. damages that may arise • Connect the product to a...
instructions for safety and environment running unless necessary. way and understand the Be careful for the rush of hazards involved. Children hot steam when you open shall not play with the the door. appliance. Cleaning and user maintenance shall Intended use not be made by children •...
instructions for safety and environment Transportation of the recycling of electrical and electronic equipment. Please product consult your local authorities If you need to move to learn about these collection the product, do it centers. in upright position Compliance with RoHS and hold from the Directive rear side.
Dishwasher Technical specifications Compliance to standards and test data / EC declaration of conformity This product complies with the following EU directives; Development, production and sales stages of this product comply with the safety rules included in all pertaining European Community regulations. 2014/35/EU, 2014/30/EU, 93/68/EC, IEC 60436/DIN 44990, EN 50242 Power input 220-240 V, 50 Hz (see rating label)
Installation Appropriate installation location Refer to the nearest Authorised Service Agent for installation of your • Place the product on a solid and product. To make the product ready flat floor that has sufficient load for use, make sure that the electricity, carrying capacity! The product must tap water supply and water drainage be installed on a flat surface in order...
Installation Connection to the drain Permitted water temperature: up to 25°C Water discharge hose can directly be The dishwasher may not be connected connected to the drain hole or sink’s to open warm water devices or flow- drainage. The length of this connection through water heaters.
Installation Aquasafe+ Electrical connection (depends on model) Connect the product to a grounded The Aquasafe+ system protects against outlet protected by a fuse complying water leaks that may occur at the with the values in the “Technical hose inlet.Water contact with the valve specifications”...
Installation If the product has a failure, it should not be operated unless it is repaired by the Authorised Service Agent! There is the risk of electric shock! Initial use Before starting to use the product, make sure that all preparations are made in accordance with the instructions in sections “Important safety instructions”...
Preparation Tips for energy saving Adjusting the water softening system Following information will help you use the product in an ecological and Cleaning, rinsing and drying energy-efficient manner. performance of your dishwasher will Wipe away any coarse food remnants increase when water softening system on the dishes before putting them in is adjusted properly.
Page 14
Installation Use the test strip supplied with the product according to the steps given below to determine hardness level of your supply water. Remove the test Turn on the tap and Hold the test strip in Remove the test Wait for 1 minute. The test strip shows strip from the let the water run for...
Preparation 1. Firstly, take the lower basket out to If you move your house, add softening salt. it is necessary to readjust water hardness level of your 2. Turn the salt reservoir lid counter- machine by considering the clockwise to open it (A). information given above according to the hardness level of the supply water...
Preparation You need to add salt right Do not put solvents into the before starting the machine. detergent dispenser. There Thus, the overflowing is the risk of explosion! salty water will be flushed Put the detergent into the detergent immediately, preventing dispenser just before operating the the risk of corrosion in machine as illustrated below.
Preparation Tablet detergents In addition to the conventional tablet detergents, there are also commercially available detergent tablets that show water softening salt and/or rinse aid effect. Some types of these detergents contain special- purpose components such as glass and stainless steel protectors. These tablets show their effects up to a 3.
Preparation 1. Open the lid of the rinse aid Contact the detergent reservoir with the help of the latch. manufacturer if your dishes are wet and/or if you notice limescale spots particularly on your glasses after the washing programme is over when using a tablet detergent.
Preparation Placing the dishes into the Wipe clean any spilled dishwasher rinse aid outside the reservoir. Rinse aid that You can use your dishwasher in the spilled accidentally will optimum way with respect to energy cause foaming and it will consumption and washing and drying eventually decrease washing performance only if you place the...
Page 20
Preparation Suggestions for loading the dishwasher Improper Loading Of Dishware Lower basket Upper basket Improper Loading Of Dishware /45 EN...
Preparation Cutlery basket Cutlery basket (depends on model) (depends on model) Cutlery basket is designed to wash Cutlery basket is designed to wash your dishes such as knife, fork, spoon, your dishes such as knife, fork, spoon, etc. in an efficient manner. etc.
Preparation Collapsible lower basket tines Bringing the tines to the horizontal position by (depends on model) holding them from the There are foldable tines (A) located tips may cause them to at the lower basket of the machine bend. Therefore, it will be are designed for an easier placement appropriate to bring the tines of large pieces such as pans, bowls,...
Preparation SoftTouch Accessory (depends on model) The SoftTouch Accessory found in the lower basket of your machine enables a safe washing for your fragile glasses. Bringing the tines to the horizontal position by holding them from the tips may cause them to bend.
Preparation Lower basket multipurpose / Make sure that the impeller height adjustable service rack does not touch the dishes (depends on model) you placed on the racks. This accessory located at the lower basket of your machine allows you To close the racks: to easily wash pieces such as extra 1.
Preparation Upper basket height Upper basket multipurpose adjustable rack service rack (depends on model) (depends on model) Use the lower and upper parts of the This accessory located at the upper height adjustable racks in the upper basket of your machine allows you to basket of the machine by sliding them easily wash pieces such as extra long down or up according to the heights of...
Preparation Adjusting the height of the To lower the basket, while it is in the uppermost position; upper basket 1. Hold the upper basket wires with (depends on model) both hands, slightly lift up the The upper basket height adjustment basket and simultaneously push mechanism has been designed for and release the latches shown in...
Preparation Collapsible upper basket Height setting with empty wires basket (depends on model) (depends on model) You can use collapsible wires when In this model, the height setting of the you need a larger space for your upper basket may be changed using dishes in the upper basket of your the wheels which are mounted at two machine.
Preparation Ceiling cutlery basket (depends on model) Ceiling cutlery basket is designed to wash your cutlery items such as forks, spoons and etc. by placing them between the bars on the basket. When the central tray is in the lower position, you can load long/high items such as coffee cups, ladles, etc.
Operating the product 1. On/Off key 2. Programme Selection / Programme Cancel (3 seconds) key 3. Function keys Tablet detergent function Half Load function 4. Programme indicator 5. Salt indicator Not in use 7. Start / Cancel indicator 8. Time Delay / Programme Time indicator 9.
Operating the product Keys Preparing the machine On/Off key 1. Open the door of the dishwasher. When you press On / Off key, indicator 2. Place the dishes in accordance lights illuminate on the display for ON with the instructions in the user position.
Operating the product Auxiliary functions Tablet detergent function Washing programmes of your Allows to obtain a better drying dishwasher are designed to obtain the performance from the multi-purpose best cleaning effect, considering the detergents called as all in one type of the soiling, soiling degree and detergents such as 2in1, 3in1, 4in1, properties of the dishes to be washed.
Operating the product Scheduling the washing time Floor illumination Warning to show that machine is in Time Delay washing phase If an economical electricity tariff is (depends on the model) applied in your region, you can use Your machine reflects a light to the the Time Delay function to wash your floor during the washing process.
Operating the product To cancel the Time Delay function The machine will remain Open the door of the product Press silent in pause mode for and hold the Programme Selection some time in order to / Programme Cancel keys for 3 remove the water from the seconds.
Operating the product End of programme Rinse Aid indicator ( ) When the programme you Please check the rinse aid indicator have selected comes to an on the display to see whether there is end, an audible warning adequate amount of rinse aid in the signal will warn you to turn dishwasher or not.
Operating the product Water cut-off warning If mains water is cut or water inlet tap is turned off the machine cannot take water in and E:02 icon will flash on the programme indicator. As long as the problem continues, washing programme is paused and the water inlet is checked regularly by the machine;...
Maintenance and cleaning Cleaning the filters Service life of the product extends and frequently faced problems decrease if Clean the filters at least once a week it is cleaned at regular intervals. in order for the machine operates efficiently. Check if food residues are Unplug the product and turn left on the filters.
Maintenance and cleaning Cleaning the hose filter Damages on the machine that may be caused by impurities coming from the urban supply water or your own water installation (such as sand, dirt, rust, etc.) can be prevented by means of the filter attached to the water inlet hose.
Maintenance and cleaning Cleaning the impellers Upper impeller Clean the impellers at least once a Check if the holes on the upper week in order for the machine operates impeller (1) are clogged. If they efficiently. are clogged, remove and clean the Lower impeller impeller.
Troubleshooting Machine does not start. • Power cable is unplugged. >>> Check if the power cable is plugged in. • Fuse is blown. >>> Check the fuses in your house. • Water is cut. >>> Make sure that the water inlet tap is open. •...
Page 41
Troubleshooting Dishes are not dry at the end of cycle • Dishes are not placed orderly in the machine. >>> Place your dishes in a way that no water will accumulate in them. • Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary.
Page 42
Troubleshooting • Water hardness setting is low or salt level is insufficient >>> Measure the hardness of the supply water appropriately and check the water hardness setting. • Salt leakage exists. >>> Pay attention not to spill salt around the salt filling hole while adding salt.
Page 43
Troubleshooting they are used for purposes such as opening cans. Do not use metal kitchen utensils out of their intended uses. • Cutlery are made of low quality stainless steel. >>> Corrosion on such items is inevitable; they should not be washed in dishwashers. •...
Page 44
If you cannot eliminate the problem although you follow the instructions in this section, consult Gram Service. Never try to repair a nonfunctional product yourself. 18 7325 0100_AC_GRAM_E5_EN/ 29-08-19.(14:21)
Need help?
Do you have a question about the OMI 62-07 and is the answer not in the manual?
Questions and answers