Maxcom MM426 User Manual page 13

Never connect the charger while the back cover is
removed.
TO CHARGE THE PHONE:
1. Plug the charger into the power outlet.
2. Plug the charger cable into the charger slot on
bottom edge of the phone. A notification about
connecting the charger will appear on the display
screen, and the battery icon will keep blinking as
long as the battery is in the process of charging.
You can also charge the phone by using the
desktop charger. To do so, plug the charger cable
into the slot located on the back of the desktop
charger, and place the phone on the desktop
charger base. A notification about starting the
charging process will appear.
3. As soon as the battery is fully charged, disconnect
the charger from the phone, and then unplug the
charger from the power outlet.
As soon as the charging process is complete, a
notification „Battery Full" will appear on the display
screen, and the battery icon will stop blinking.
Important:
o Prior to starting the charging process, make sure the
battery is properly installed.
o Never remove the battery while charging – doing so
might damage the phone.
13