Related Manuals for Sprayers Plus CR275 CONCRETE PRO
Summary of Contents for Sprayers Plus CR275 CONCRETE PRO
- Page 1 C R 2 7 5 CONCRETE PRO XYLENE / DIESEL / FORM OIL / CURING COMPOUND / I n s t r u c t i o n M a n u a l DEGREASER / WATER BASED SEALANTS I NS T RU C T I O N M A NU A L...
-
Page 2: Table Of Contents
INDEX Index ......... 1 DANGER! Unpacking . -
Page 3: Unpacking
UNPACKING ASSEMBLY Securely tighten the User Manual 6 locations indicated here to prevent leakage Pump Spray Gun Module Shoulder Attaching the Shoulder Strap to Strap the tank: From the top of the bottom, there Silicone are three slots to secure the strap Grease on these slots. -
Page 4: Specifications
IMPORTANT PRODUCT NOTE SPECIFICATIONS CR275 CONCRETE PRO SprayersPlus produces top quality products meeting the highest standards in the industry. Target Market Industrial Construction To ensure your safety, optimize the user experience and maximize the life span of this Engineered for spraying xylene, diesel, gasoline,... -
Page 5: Warning
WARNING ! CAUTION ! IMPROPER USE OR FAILURE TO FOLLOW INSTRUCTIONS CAN RESULT IN • Refrain from operating the sprayer if you are tired, ill, or upset, or if you are EXPLOSION CAUSING SERIOUS EYE OR OTHER INJURIES. under the influence of alcohol, drugs or medication. FOR THE SAFE USE OF THIS SPRAYER, YOU MUST READ AND FOLLOW •... -
Page 6: Preparation For Spraying
PREPARATION FOR SPRAYING PREPARATION FOR SPRAYING WEAR PROTECTIVE GEAR • Always inspect your sprayer thoroughly before and after each use. Check to be sure everything is securely attached and in good condition before pressurizing the tank. • Check the work area that the sprayer will be used in and remove or cover all valuables that may be damaged by using sprayer. -
Page 7: Wand Placement
PREPARATION FOR SPRAYING PREPARATION FOR SPRAYING LOCK & UNLOCK WAND PLACEMENT THE PUMP HANDLE Pull out the plastic catch This pump handle is also engineered for carrying/transporting the unit when it is in the locked position. To unlock the handle (from the locked position), gently turn it clockwise. When the handle is in the To lock the handle (from the unlocked position, it can... -
Page 8: Clean Up, Storage & Transport
CLEAN UP, STORAGE & TRANSPORT MAINTENANCE Units are not storage tanks and should be washed and cleaned after each use. Failure to maintain the unit may damages the o-rings and seals and may void the manufacturer's • After using the sprayer, CLEAN UP (unless spraying is to be continued within hours). warranty. - Page 9 REPLACEMENT PARTS DIAGRAM A REPLACEMENT PARTS - DIAGRAM B HOSE, WAND AND O-RINGS K4028 K4035 K5008 K8051 K3018 PRESSURE COMPLETE PUMP O-RING SET SHOULDER PADS RELIEF VALVE MODULE FOR PRESSURE K7109 (CONCRETE PRO RELIEF VALVE SPRAYER) K2048 PUMP TUBE CAP K3030 (2 HALVES) K8049...
-
Page 10: Replacement Parts - List
REPLACEMENT PARTS - LIST NOZZLE & PERFORMANCE Steam Mist setting Coverage Steam setting setting output @ 3.3’ output Pressure Type Sprayer Models Horizontal height (psi/kg) (ml/min) (ml/min) reach K2031 PUMP PLUNGER K4035 O-RING SET FOR PRESSURE + /- 100ml (feet) + /- 100ml (feet) -
Page 11: Notes
N O T E S R E T U R N I N S T R U C T I O N S _______________________________________________________________________ If it is necessary to return the sprayer for repair, always _______________________________________________________________________ perform the following tasks before returning the sprayer: •... -
Page 12: Warranty Info
_______________________________________________________________________ Warranty Registration Please visit: www.sprayers-plus.com/warranty _______________________________________________________________________ Sprayers Plus shall honor this warranty, free of charge, if any part or component shows _______________________________________________________________________ defect in MATERIAL OR WORKMANSHIP, after final analysis at the factory. _______________________________________________________________________ This Warranty shall exclude...
Need help?
Do you have a question about the CR275 CONCRETE PRO and is the answer not in the manual?
Questions and answers