Haier H3SM- - annexe 2 Installation Manual page 5

Note: When connecting the cable, confirm the terminal number of indoor and outdoor units carefully. If wiring
is not correct, proper operation can not be carried out and will cause defect.
1. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar
qualified person. The type of connecting wire is H05RN-F or H07RN-F.
2. If the fuse on PC board is broken please change it with the type of T. 3.15A/250V.
3. The wiring method should be in line with the local wiring standard.
4. After installation, the power plug should be easily reached.
5. A breaker should be incorporated into fixed wiring. The breaker should be all-pole switch and the
distance between its two contacts should be not less than 3mm.
Indoor unit A
Indoor unit C
Indoor unit B
5.Easily-demount cleaning of indoor unit
1.Top inlet can be taken down
Open the inlet grille, press the claw of the clip on the unit,then
take down the top inlet.(according to figure 1)
2.Vertical flap can be taken down
Overturn the vertical flap, press the claw of the clip ,then take
down vertical flap.(according to figure 2)
3.Horizontal louvers can be taken down
After taking down vertical flap.Horizontal louvers are appeared,draw
the middle louver,and take down the horizontal louvers .
(according to figure 3)
Indoor unit
WHT
YEL/GRN
RED
RED
BLK
YEL/GRN
BLK
WHT
YEL/GRN
WHT
RED
RED
BLK
BLK
YEL/GRN
WHT
YEL/GRN
WHT
RED
RED
BLK
BLK YEL/GRN
WHT
BRN
BLU
YEL/GRN
Outdoor unit
5
claw of the clip
Figure 1
Figure
2
Figure 2
Daff
Figure 3