Haier AE122FCAKA Instruction Manual page 8

D
Remote LCD display contents and key name and each key function introduction
B A
11
12
AUTO ion
13
14 OFF
H
T E M P
ON
OFF
HEALTH FAN
SWING
MODE
4
TIMER
LOCK
RESET CODE
6
21
Make sure that the remote controller is used within 7 meters from receiver window
of the wire controller and there are no obstructions in between.
The remote controller or wire controller should be handled with care.
When operating the remote controller in an area
where electronically controlled lights are
installed or wireless handsets are used, move
closer to the indoor unit as the function of the
remote controller might be affected by signals
from this equipment.
Note:
1.After change the battery, working condition resume as follows:
2.The units used in this manual no 8 18 functions. The health key can only control the
negative generator.
20
1.ON/OFF button
Used to turn on/off unit
2.Temperature Setting button
15
16 Used to set temperature,
temperature range: 16 C~30 C
17
3.Health
18
Used to control the
19
generating oxygen function
2
and negative ion-function
7
4.Operation mode button
8
Used to set working mode:
Cooling, Dehumidifying,
Heating
9
5.Timer button
Used to set the
mode of timer
10
6.Reset button
When the remote
controller appears
abnormal condition,
use a sharp-pointed
article to press this
button to make the
wire controller
resume normal
7.Fan speed button
Used to set fan speed
8.Swing button
Used to set Auto Swing or
Fixed air sending direction
9.Time Adjusting button
10.Lock button
Press on time lock all the
key sand press another time
concel the lock.
11.Working mode display
Working mode:cooling
Timming mode: normal
7
12.Fan speed display
Used to display the fan
speed. After setting
"AUTO" function,air speed
can auto change according
to the temp. difference
between the room temp. and
setting temp.
13.Health running display
Used to display healthy
running.
14.Timer ON/OFF display
Display Timing mode.
"Blank" No Timing
" " Timing off
OFF
" " Timing on
ON
15.Signal display
Sending out signal to the
remote receiver.
16.Temperature display
Display the setting temp.
value.
17.Lock display
Display the key have been
locked.
18.Super/Soft operation display
19.Timing time display
Display timing open time
or timing close time
20.Signal launch head
Use to send signal to the
indoor unit receive window.
21.Code
Select remote control receive
code(H-MRV Remote cnotrol
type use A code)
R
Temp. 26 C
Air speed: Auto