Haier AE122FCAKA Instruction Manual page 6

D
13
12
11
10
9
8
7
6
5
4
3
2
1
1.ON/OFF button
Used to turn on/off unit
2.Temperature display
3.Clock display
4.Timer ON/OFF display
5.Humidity display
6.Air filter cleaning display
When there is too much dust
collected on the air inlet, the
wire controller will show
this display to remind the
user to clean the air inlet.
After cleaning and installation,
*
just press the air filter reset button.
7.Super/Soft operation display
8.Fan speed display
Low Fan Med Fan High Fan Auto
9.Auto Swing display
10.Health state display
11.Fresh air state display
12.Humidifying state display
Note:
1.This model does not have the following related
display and function
2.The outdoor unit no oxygen-bar function or no negative ion
10
19
unit no
Calibration of clock
When turning on the unit for the first time, the clock should be calibrated. The method
of calibration is:
1.Press ì Clockî button, the Clock display ì AMî ì PMî will flash.
2.Press or to adjust time. For each press, the time will increase or decrease 1
*
minute. If depressing the button, the time will increase or decrease rapidly.
3.After confirming the time, press ì Setî button, ì AMî or ì PMî will stop flashing,the
clock will begin to work.
14 15 16 17 18 19
MODE FAN SWING
AUTO
TEMP HEALTH
SET
CLOCK
SLEEP
TIMER
SET
SUR
FILTER RESET
RESET
ON/OFF
13.Sleep state display
14.Network control display
15.Working mode display
Working Auto Cooling
mode operation operation
Wire
controller
16.Electric heating display
17.Operation mode button
Used to set working mode:
Auto, Cooling, Dehumidifying,
Heating, Fan
18.Fan speed button
Used to set fan speed: Low
Fan, Med Fan, High Fan, Auto
19.Swing button
Auto
Used to set Auto Swing or
Fixed air sending direction
20.Temperature Setting button
Used to set temperature,
temperature range: 16 C~30 C
21.Clock button
Used to calibrate the time of
timer and clock
11 12 14 16 26
5 6 7 9
healthl function display.
5
22.Setting button
20
29
23.Sleep button
21
22
23
24.Time Adjusting
24
25
26
27
28
30
Dehumidifying Heating Fan
operation operation operation
26.Air Filter Reset
27.Timer button
28.Lock state display
29.Health
30.Remote control window
Used to confirm
the time of timer
and clock
Used to set Sleep
state
button
Used to adjust the
time of timer and
clock
25.Reset button
When the wire
controller appears
abnormal condition,
use a sharp-pointed
article to press this
button to make the
wire controller
resume normal
button
After cleaning the
air inlet, press this
button, the unit
can start to operate
Used to set the
mode of timer
Used to control the
generating oxygen
function and negative
ion-function
Used to receive the
remote control signal