HUBER+SUHNER CDR300 Installation Manual

INSTALLATION
MANUAL
CDR - Cable Distribution Rack

Table of contents

•
REQUIRED TOOLS ........................................................................................................ 1
•
REMOVAL OF DOORS AND SIDE PANELS ................................................................. 2
•
CHANGE OF COVERS ON THE BACK ......................................................................... 3
•
MOUNTING OF CDR300 ON A FIXED FLOOR- CONCRETE FIXATION ................... 4
•
MOUNTING OF CDR300 ON A RAISED FLOOR .......................................................... 5
• MOUNTING OF CDR600 ON A FIXED FLOOR - CONCRETE FIXATION .................. 8
•
MOUNTING OF CDR600 ON A RAISED FLOOR ........................................................ 10
• MOUNTING OF CDR900 ON A FIXED FLOOR - CONCRETE FIXATION ................ 12
•
MOUNTING OF CDR900 ON A RAISED FLOOR ........................................................ 14
• MOUNTING OF CDR1200 ON A FIXED FLOOR - CONCRETE FIXATION .............. 17
•
MOUNTING OF CDR1200 ON A RAISED FLOOR ...................................................... 18
•
ASSEMBLY OF CDR1500 ............................................................................................ 21
•
MOUNTING OF CDR1500 ON A FIXED FLOOR- CONCRETE FIXATION ............... 22
•
MOUNTING OF CDR1500 ON A RAISED FLOOR ...................................................... 24
•
MOUNTING OF CAGE NUT ......................................................................................... 26
•
MOUNTING OF ROUTING CHANNEL ......................................................................... 27
•
MOUNTING OF CABLE RETAINER ............................................................................. 30
•
DEMOUNTING / MOUNTING OF MANDRELS ............................................................ 31
•
MOUNTING OF GROUNDING CABLES / EARTH KIT ................................................ 31
•
BAYING RACKS TOGETHER SIDE BY SIDE ............................................................. 32
•
BAYING RACKS TOGETHER BACK TO BACK .......................................................... 33
•
MOUNTING OF RACK AGAINST A WALL .................................................................. 33
•
MOUNTING OF RACK TO CEILING ............................................................................ 34
•
MOUNTING OF DOORS AND SIDE PANELS ............................................................. 34

REQUIRED TOOLS

Step 1
Flat combined open-end wrench 12mm /
screwdriver 6 supplied together with rack
HUBER+SUHNER disclaims any liability resulting from incorrect installation and use, including any damages resulting from the use of tools and
accessories other than the ones recommended herein. Any installation performed by unqualified personnel voids the product warranty provided by
HUBER+SUHNER. All due care and attention must be exercised when performing the installation of these products. For advice concerning the
general handling of these products please contact HUBER+SUHNER.
Step 2
• Long PZ / Phillips #2
• PZ / Phillips #3
• Combination spanner AF=
10 mm (M6) and 17mm (M10)
HUBER+SUHNER AG
Fiber Optics
Fiber Management Systems
DOC-0000719356 Rev G
Date: 20/12/2018
Page 1 of 35
Step 3
Tools for mounting CDR on a fixed or raised floor