All about the Use &Care of your Room Air Conditioner TA B L E O F C O N T E N T S Important Safety Instructions ....... 2-3 Operating Instructions ......... 5-10 Care and Cleaning ..........11 Product Registration ..........
Do not insert or place fingers or objects into the air discharge area in the front of the unit. Do not start or stop the air conditioner by unplugging the power cord or turning off the power at the electrical box.
SAFETY PRECAUTIONS CAUTION! Avoid Injury or damage to the unit or other property Provide occasional ventilation during use. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make units run excessively.
Product Registration, Packaging & Normal Sounds Product Registration Record Your Model and Serial Numbers Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Model No.
& REMOTE SENSING BUTTON Operating Instructions NOTE The following instructions represent the Touch Pad, the same instructions can be used for the Remote Control. TO TURN UNIT ON: YOU WILL SEE: DO THIS: PRESS ON/OFF BUTTON 2009 Electrolux Home Products, Inc.
Page 6
PRESS TO LOWER 60 °F (16 °C) and 90 °F (32 °C) . If you want the display to read the actual room temperature. See "To Operate on Fan Only" section on Page 7.
Page 7
YOU WILL SEE: TO USE THE ENERGY SAVER (ECON) FEATURE: Note: In this mode, the fan will continue to run for 1 minu- DO THIS: te after the compressor shuts off. The fan then cycles on for 20 seconds at 10 minute intervals until the room tempe-...
Page 8
) to change delay timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool, Energy Saver, or Fan Only was the last mode selected) .
Page 9
” buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself ). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal.
Page 10
The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees. After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored. Fresh Air Vent Control (on some models) The Fresh Air Vent allows the air conditioner to: 1.
Air Filter Cleaning The air filter should be checked at least once a month to see if cleaning is necessary. Trapped particles in the filter can build up and cause an accumulation of frost on the cooling coils.
Before You Call Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. OCCURRENCE SOLUTION Air conditioner will not operate.
Major Appliance Warranty Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.