Page 10
※ Extract bad water before install 1. Direct the supply hose end into a 3 gal (11.4l)or larger bucket. 2. Make sure that the supply stop can provide a minimum of 1.5gal (5.7l)or more in 10 seconds. 3. Shut off the water supply. Proceed to next step 390 x 660 x 550mm / 15.35 x 25.98 x 21.65 in 415 x 700 x 545mm / 16.33 x 27.55 x 21.45 in...
Page 16
- TCB 9100GA / TCB 9100WA - TCB 8200SA / TCB 8200SA (Black) - Press Turbo button, Turbo wash will operate. - It starts from the lowest water pressure for safety reason. - After using the Turbo wash, the posterior and feminine wash pressure will automatically lowered to 1 level.
Page 19
- TCB 9100G / TCB 9100W - TCB 8200S / TCB 8200S (Black) - In power saving mode, if left unused for more than 1 hour, both the water temperature and seat temperature are reduced by one level compared to their current settings.
Page 20
- TCB 9100G / TCB 9100W - TCB 8200S / TCB 8200S (Black) -En mode économie d'énergie, si vous ne l'utilisez pas pendant plus d'une heure, la température de l'eau et celle du siège seront maintenues à un niveau inférieur d'un cran par rapport aux réglages d'origine pour économiser de l'énergie.
Page 27
Is the bidet power on? Unplug the power cord, wait for (For check the power LED on the 5 minutes, then plug it back and body display unit.) check the power. For if the power+power-save LED on the main unit are flashing together, it indicates a water supply issue.
Is the bidet power on? Unplug the power cord, wait for (For check the power LED on the 5 minutes, then plug it back and body display unit.) check the power. For if the power+power-save LED on the main unit are flashing together, it indicates a water supply issue.
Page 29
0.15 MPa is required. Please clean the strainer filer, too weak? flushing please refer the troubleshooting guide on www.vovo-us.com website. If the water pressure still weak please email to support@vovousa.com Has any large debris (sanitary pads, Use a plunger or call a technician toothbrushes, etc.) been flushed...
Page 30
All wash function Is the seat sensor blocked with wet Remove the wet towel. or deodorant towel? function operates without someone Is the area where the seat sensor is Use a dry cloth to wipe away the sitting on the seat. located wet? water.
Have you replaced the remote Replace with new batteries and control batteries? Have you inserted check the polarity. Refer to page them correctly? Are the battery polarities Insert the batteries in the correct reversed? order. Remote Are the transmitter of the remote Remove any obstruction that may control is and the receiver on the main unit...
Need help?
Do you have a question about the TCB 9100GA and is the answer not in the manual?
Questions and answers