Advertisement
÷
Air Conditioner
Features
(continued)
COOUNG
MODE:
mn this mode the exhaust
adaptor hose MUST be used.
1. Press the MODE button until the "CooF indbator Hghts.
2. Press the "A %/" Temp buttons for dssired setting.
3. Press the FAN button for desired fan speed.
HEAriNG
MODE:
(on select
mode_s)
mnthis mode you do not need to use the exhaust adaptor
hose.
1. Press the MODE button until the "Heat" indicator lights.
2. Press the ",A V "Temp buttons up or down for the desired heat setting.
3. Press the FAN button for the desired fan speed.
DRY MODE:
in this mode you do not need to use the exhaust
adaptor
hose, BUT the
water collected
must be discharged.
See Drainage Section.
1. Press the MODE button until the "Dry" indicator lights.
2. The fan will run at a fixed speed and the display will go dark.
3. Keep doors & windows closed for best effect.
÷
FAN MODE:
In this mode there is no requirement
to use the exhaust
hose or drainage
hose. However,
if you require stab or smokey
air to be removed
from the
room, hook up the duct accessories
as described
in the "EXHAUSTHNG HOT
AHR" section.
1. Press the MODE button until the "Fan" indicator lights.
2. Press the FAN button to choose the desired fan speed.
3. The fan will run at the selected speed and the display will go dark.
÷
TIMER OPERATION:
To start unit at a pre-determined
time:
Make sure that the appliance is in the same mode you will need when it turns back
on. Then turn the unit off.
Press the "Timer On" button. The display will read "0.00"
Pressing the "Timer On" button will change the time in half-hour increments up to
10 hours, then full hour increments up to 24 hours. The appliance will switch on
after the allotted time. To cancel at any point simply adjust the "Timer On" button to
0.00.
To stop unit at a pre-determined
time:
The appliance must first be operating in the selected mode.
Press the "Timer Off" button. The display will read "0.00"
Pressing the "Timer Off" button will change the time in half-hour increments up to
10 hours, then full hour increments up to 24 hours. The appliance will switch off
after the allotted time. To cancel at any point simply adjust the "Timer Off" button to
0.00.
To Start/Stop
and to Stop/Start
The appliance can be programmed to do either. Just follow the instructions above
in the order that you require. When programmed, you will see both timer indicators
lit.
TEMPERATURE
DISPLAY:
The display can be changed to read either Fahrenheit (°F), or Celsius (°C). To do
this simply hold the "A V "Temp buttons for three seconds.
Note: the remote can only display the temperature in Fahrenheit (°F).
SZ000373(
En)-YaoKong(p6-11)
8
_
2004.11 8, 4:02 PM
Advertisement
