Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Frigidaire Manuals
  4. Air Conditioner
  5. FAP094
  6. Use and care manual

Frigidaire FAP094 Use And Care Manual

Electronic control
Hide thumbs

Advertisement

Quick Links

Download this manual
USE & CARE MANUAL
THIS PORTABLE AIR CONDITIONER
IS EQUIPPED WITH A NEW INDUSTRY
STANDARD POWER SUPPLY CORD WITH A TEST-RESET
FUNCTION
READ AND SAVE THESE INSTRUCTIONS
PORTABL
AI R CON DITION ER
ELECTRONIC
CONTROL
P/N 220250d396
SZ000373(En)-YaoKong(pl-5)
1
2004.11.10,
4:54 PM

Advertisement

loading

Related Manuals for Frigidaire FAP094

Summary of Contents for Frigidaire FAP094

  • Page 1 USE & CARE MANUAL THIS PORTABLE AIR CONDITIONER IS EQUIPPED WITH A NEW INDUSTRY STANDARD POWER SUPPLY CORD WITH A TEST-RESET FUNCTION READ AND SAVE THESE INSTRUCTIONS PORTABL AI R CON DITION ER ELECTRONIC CONTROL P/N 220250d396 SZ000373(En)-YaoKong(pl-5) 2004.11.10, 4:54 PM...

  • Page 2: Warranty

    The date on the bill establishes the warranty period should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. This written warranty gives you specific legal rights. You may also have other rights that vary from state to state. Service under this warranty must be obtained by following these steps, in order: 1.

  • Page 3: Table Of Contents

    Product Registration Record Your Model and Serial Numbers Record in the space provided below the model and serial numbers. On a!l models, the serial plate is located on the outside of the cabinet. Model No. Serial No. Register Your Product...

  • Page 4: Important Safety Instructions

    Important Safety Instructions For Your Safety Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Read product labels for flammability and other warnings. The power supply cord with...
  • Page 5 Always make sure the RESET button is pushed in for correct operation. The power supply cord must be replaced if it fails to reset when either the TEST button is pushed, or it cannot be reset. A new one can be obtained from the product manufacturer.
  • Page 6 TEMPERATURE CHANGEBUTTONS Power r ¸- _ ....REMOTE SIGNAL Timer ..RECEWER _"....triode ... "\_-. ON / OFF BUTTON TIMER RUTTONS Fig.3 REMOTE CONTROL MODE INDICATION Set Temperature F° _ool High "-AAuto [ 1 Fan FAN SELECTION N* Heat...

  • Page 7: Air Conditioner Features

    Attach the exhaust adaptor to the back of the unit by placing the hinge into the slot, and then locate the right side into the toothed slots. Finally push the hose connector downwards to secure.
  • Page 8 To start unit at a pre-determined time: Make sure that the appliance is in the same mode you will need when it turns back on. Then turn the unit off. Press the "Timer On" button. The display will read "0.00"...
  • Page 9 The top left selection is an AUTO setting that will enable the appliance to determine the best mode selection against the temperature you have set. It will then run at high fan speed until the room is at the required setting, then the fan will slow down to keep _u_ ............
  • Page 10 Air Filter Cleaning The air fiiter shouid be checked at bast once a month to see if cieaning is neces- ÷ ÷ sary. Trapped parficies in the fiiter can buiid up and cause an accumulafion of frost on the cooling coiis.
  • Page 11 60°F (18°C). To defrost the coil, set FAN ONLY Mode. too warm = ice forming on cooming Air filter may be dirty. Clean filter. Refer to Care and Cleaning section. To defrost, set to FAN ONLY Mode. coil behind rear cover. Temperature is set too Low for night-time cooling.