Download Print this page

Frigidaire FAZ12ES2A Installation Instructions Manual page 5

Installation instructions

Advertisement

Install Cabinet into Window
1,
2,
3.
Handle the air conditioner gently.
Be sure your air conditioner
cabinet does not fall out of the
opening during installation or removal.
The place where the power cord exits the air conditioner
should be no more than 4 it (1 22 cm) from a grounded
3 prong outlet.
Do not block the louvers on the front panel.
Do not block the louvers on the outside of the air conditioner.
Center empty cabinet in window. Check that lower rail of air
conditioner
cabinet is behind and against back side of
windowsill.
Maintain a firm hold on the air conditioner
cabinet. Lower window sash to hold the cabinet in place.
Measure the distance between the right-hand side of the
cabinet and the inside of the window channel.
Repeat for the left side. Adjust the cabinet until the distance
on each side is the same.
i
i
JilA
----4,
I
B
I
Tc
I
4,
5.
A. Window
sash
B. Empty
cabinet
C. Window
channel
Use a 3/16"drill bitto drill 3 starter holes 3/8"deep through the
3 holes in the cabinet and into the windowsill.
Attach cabinet to windowsill with 3 - #10 x 1/2"pan-head
Phillips screws.
A
A
A
6,
1
A. #10x
½" pan-head
Phillips
screws
B. Windowsill
Check that air conditioner cabinet is tilted to the outside so
that water will run to the outside,
Attach Side Curtains
to Window
Frame
1. Pull the left-hand curtain out until itfits into the window
channel. Use a 3/32"drill bit to drill a starter hole through the
hole in the curtain housing and into the lower window sash.
Front View
Top View
/
,vv vvv
B
2,
A. Window channel
B. L eft-hand curtain
C. #10 x ¾" round-head
screw
Insert one of the #10 x 3/4"round-head screws through the
threaded hole in the top of the curtain.
A
B
A. #10x
¾" round-head
screw
B. Slotted
hole in the bottom
of the curtain
3. Use a 3/32"drill bit to drill
a 2 nd
starter hole through the slotted
hole in the curtain housing and into the lower window sill.
4. Insertone
of the #10 x 3/4"round-head screws through the
slotted hole in the bottom of the curtain.
5,
Repeat for the right-hand curtain.

Advertisement

loading