Danby DAC10011E Owner's Use And Care Manual page 14

Operating Instructions
USING THE REMOTE
CONTROLLER
BUTTONS
ON/OFF MODE
TEMP TEMP
S
UP DOWN
ENERGY
SAVER
TIMER
FAN
CLEAN SLEEP
AIR
NOTE:
To cancel the TIMER setting, push the TIMER button until 0 hour is
displayed on the LCD window of the air conditioner.
ON/OFF MODE
TEMP TEMP
S
UP DOWN
ENERGY
SAVER
TIMER
FAN
1
SLEEP
CLEAN
AIR
1
ON/OFF MODE
TEMP TEMP
S
UP DOWN
ENERGY
SAVER
TIMER
FAN
CLEAN SLEEP
AIR
13
TIMER OPERATION
To set the Auto-start time.
1) Push the TIMER button when the unit is
operational, only the Auto-stop feature
can be set.
2) Keep pressing the TIMER button, each
press will increase the selected time by
1
1 hour increments, up to 12 hours.
3) The time can be set in a range of 0~12
hours.
4) After the desired time has established,
wait for about 10 seconds until the
setting temperature reverts back in the
display window of the air conditioner.
This indicates the program is set.
CLEAN AIR OPERATION
When this button is pushed, the ion gener-
ator is energized and will help remove
pollen and impurities from the air. Press it
again to stop the operation.
ENERGY SAVER OPERATION
In this mode, the fan will continue to
run for 3 minutes after the compressor
shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the
room temperature is above the set
temperature, at which time the compressor
turns back on and cooling stars.