Installation - Belkin F5U402-03IN-KIT User Manual

Installation

IMPORTANT NOTE: Please do not connect any USB devices to
1
the Hub until instructed to do so in step 5 of this installation
procedure.
1. Insert the mounting ring into the desk.
2
2. Plug the included power adapter into a wall outlet or surge
suppressor, running its cable through the mounting ring. Do not
plug it into the Hub yet.
3
3. Plug the flat end of the USB device cable into the downstream
port of your computer or another hub; and run the USB cable
through the mounting ring.
4. Now, plug in the power cable's connector to the power jack on the
rear of the Hub.
Note: You can use the Hub without the power supply when
connecting low-power devices such as keyboards and mice.
5. Plug the square end of the USB device cable into the upstream
port on the rear of the Hub.
6. Place the Hub into the mounting ring.
Important Note: The Hub must be connected to a USB 2.0-
compliant host in order to function in high-speed mode (480Mbps
data rate). If the Hub is connected to a USB 1.1-compliant host, it will
operate only in low- or full-speed mode (1.5Mbps/12Mbps).
7. Windows will now detect your Hub and install the required driver.
(The Windows "Install New Hardware Wizard" may prompt you to
provide your Windows Installation CD to complete the
driver-installation process.)
Important Note: Hi-Speed USB 2.0 hub drivers are included with
most USB 2.0 PCI upgrade cards and are pre-installed along with
the PCI-card drivers. If you purchased an upgrade card prior to the
advent of Hi-Speed USB 2.0 hub support, please check with your
PCI-card vendor for an updated USB 2.0 driver.
8. Plug the USB-A connector of the USB device or additional hub
into any of the In-Desk USB Hub's downstream ports.
Important Note: When moving a device from one port to another, it
may be necessary to reinstall the USB drivers for that device.
4 4